Operation Manual
04/03/16 13:24 04/03/16 13:24
POWER IS OFF Power is off
PRESS KEY TO CONTINUE Press any key to continue
Note! :
The above test is to check whether the power board and reserved nickel-hydrogen battery work well.
The machine can distinguish the external power supply is “on” or “off”. When the external power is
“off”, there should not be system halted or resetting within one minute. Different from that of
battery voltage.
14.2 Power off test
Select Power off test and press “Enter” to begin to test, it displays as follows:
04/03/16 13:24 04/03/16 13:24
PLEASE POWER OFF Please power off
PRESS KEY TO CONTINUE Press any key to continue
To power off and press any key to stop the machine.
Note! :
The above test is to check whether the power board and reserved nickel-hydrogen battery work well.
The machine should power off normally and would not reset. The machine should not be shutdown
or reset before the external power is off.
IV System setting:
Finished downloading all ROM/OS/DISP FONT/PRINT FONT, setting the system before using it,
system setting is to be done in the first item “System configuration” of the main menu, refer to
table1-2.
1 System configuration main menu introduction
Select 1.SYSTEM CONFIG in the main menu and confirm it. There are totally two pages of
configuration menu, the display interface is as follows:
04/03/16 13:24 04/03/16 13:24
CONFIG MENU 1 Configuration menu 1
1.PRINT SETTING 1.Print setting
2.DATE/TIME SETTING 2.Date/Time setting
3.HARDWARE SETTING 3.Hardware setting
4.BATTERY SETTING 4.Battery setting
5.PRINTER SETTING 5.Printer setting
6.MODEM SETTING 6.MODEM setting
Table4-1
04/03/16 13:24 04/03/16 13:24
CONFIG MENU 2 Configuration menu 2
1.ETHERNET SETTING 1.Ethernet setting
2.ETH IP SETTING 2.Ethernet IP setting
3.GSM SETTING 3.GSM setting
4.CONTACT SETTING 4.Contact setting
5.OS SETTING 5.OS setting
Table4-2