Operation Manual

1.2.7 Save
After completion of all above setting, host will prompt as the following interface:
04/03/16 13:24 04/03/16 13:24
SAVE？ Save?
270030802001 Serial No.: 270030802001
VER 2.70 Version 2.7
ICC EXIST IC card reader exist
ETHERNET EXIST Ethernet exist
GPRS NOT EXIST GPRS not exist
Table4-14
Check all the displayed items, if true, press “Enter” to save; if not, press “Cancel” and reset it.
1.3 Battery setting
Select 4.BATTERY SETTING and confirm, the display interface is as follows: (Table4-15)
04/03/16 13:24 04/03/16 13:24
VOLTAGE 919 Voltage 919 (conversion value)
300 300（i.e. 3V）
Use 3 digits when inputting battery voltage, decimal point needs not to be input. Lack of 3digits ,
add “0”, such as: 300 refers to 3V.
Note! :
When start up system, the voltage is higher than 2.8V or lower than 3.7V, system will report error
during self checking.
1.4 Printer setting
OS identifies the printer model according to diversity of printing drive plate, different print patterns
have different setting content, hereinafter will introduce the setting of pixel printing
（EPSON-M190）, thermal printing （APS ELM205）, and Pixel printer with teeth hole paper
printing （SAMSUNG 130）respectively.
1.4.1 Pixel printer setting (EPSON M190）
Select 5.PRINTER SETTING and confirm, the display interface is as follows:
04/03/16 13:24 04/03/16 13:24
EPSON M190 Epson M190 (Pixel pattern)
NOT NEED CONFIG Need not configuration
Table4-16
Pixel printer needs not other setting.
1.4.2 Thermal printer setting（APS ELM205-LV）
Select 5.PRINTER SETTING and confirm, the display interface is as follows: