Operation Manual

04/03/16 13:24 04/03/16 13:24

VOLTAGE（V） Printing voltage （V）

70 70

APS ELM205-LV APS ELM205-LV （ Thermal printer

model）

00 00

Table4-17

When setting thermal printer, setting printing voltage at first based on different powers. Using 2

digits to stand for it, such as: 70 refers to 7V; then set the printing speed after confirmation of the

previous one, the interface is as follows:

04/03/16 13:24 04/03/16 13:24

SETP SPEED（us） Printing speed (us)

1500 1500

APS ELM205-LV APS ELM205-LV （ Thermal printer

model）

70 70

00 00

Table4-18

Set the printing speed between 800 and 4000, after confirmation then set the strobe No., the

interface is as follows:

04/03/16 13:24 04/03/16 13:24

STROBE NO. Stroke No.

192 192

APS ELM205-LV APS ELM205-LV （ Thermal printer

model）

70 70

1500 1500

00 00

Table4-19

The setting of APS ELM205-LV stroke No. should not less that 64, press “Enter” to save after

completion.

Note! :

1. Check the printing effect by way of printing test after the setting completed, adjust the printing

voltage, printing speed, and the stroke No. will gain a fast and effective printing.

1.4.3 Pixel printer with teeth hole paper printer setting (SAMSUNG 130-U）

Select 5.PRINTER SETTING and confirm, the display interface is as follows: