Operation Manual

PRESS KEY TO CONTINUE Press any key to continue
TRACK 2 refers to track 2;
0 refers to the condition of track is correct, other No. refer that the condition is incorrect;
LEN 37 refers to the length of track;
601428．．．．refers to information of track
Press any key to display information of track 3, which is basically similar to that of track 2, and
then press any key again to display information of track 1.
Note! :
(1) The length and information of track is diversity according to the difference of magnetic card.
(2) The magnetic head should be 2&3 head or 1&2&3 head according to that of POS.
(3) When swiping the card, there should not be kind of feeling such as over strain, over loose, or
resistance, there should be no abnormal phenomena of not reading the card, not reading track 1, 2,
and 3 (there are no figure display in track 1, 2, and 3), or system halted when reading the card.
(4) When taking the test of swiping card, at least three different bank cards should be tested, and
each card should be tested at least three times. The standard of qualification of the test is that the
machine should word well during the test of any card whenever. And please do not too prompt or
too slowly while swiping the card.
6 IC card test
Select5．IC and press “Enter” to begin to test, the host would display as follows:
04/03/16 13:24 04/03/16 13:24
ICC TEST MENU 1 IC card test menu 1
1．ASYNC CARD TEST 1 Asynchronous card test
2．SYNC CARD TEST 2 Synchronous card test
6.1 Asynchronous card test
Select1．ASYNC CARD TEST to begin to test and enter into the following interface:
04/03/16 13:24 04/03/16 13:24
INSERT PBOC CARD Insert PBOC card
PRESS CANCEL TO EXIT Press “Cancel” to exit
Insert PBOC test card and display as follows:
04/03/16 13:24 04/03/16 13:24
ANSWER TO RESET： Resetting response
3B6F0000535441522043 3B6F0000535441522043
48494E412056313130 48494E412056313130
PRESS KEY TO CONTINUE Press any key to continue
Press any key to continue and display as follows: