Operation Manual

Insert SAM test card into SAM slot, then input correspondent SAM slot No, host displays as
follows:
04/03/16 13:24 04/03/16 13:24
SAM NO.： 1 SAM slot No. 1
ANSWER TO RESET： Retting response
3B690000249987005341 3B690000249987005341
0E141E 0E141E
PRESS KEY TO CONTINUE Press any key to continue
Press any key and display as follows:
04/03/16 13:24 04/03/16 13:24
SELECT 1PAY．SYS．DDF01 Select file
6F15840E315041592E53 6F15840E315041592E53
59532E4444463031A503 59532E4444463031A503
8801019000 8801019000
90 00 90 00
3B6F000．．．and 6F15840．．．are Resetting response and select file data respectively, since there
would be diversity as per of difference of cards;
90 00 refers to the card is in correct condition, other figures all mean incorrect.
Press “Cancel” can return to SAM card test menu, then input other SAM wipe No. and begin to test
the other two slots.
Note! :
(1) If SAM card does not inset into the SAM card slot, machine will give promptness, and display
in the bottom of screen as:
ERR：RESET RESULT 02 Resetting error
(2) The touch spot should not be uneven or cracked when inserting the SAM card, and there should
be no abnormal phenomona such as system halted or resetting etc when cheking.
8 Serial port test
Select the second item 1．UART in the hardware test menu, and display as follows:
04/03/16 13:24 04/03/16 13:24
UART TEST MENU 1 Serial port test menu 1
1．COM1&2 TEST 1．COM1 and COM2 test each other
mutually
2．COM1 TEST 2．COM1 test
3．COM2 TEST 3．COM2 test
Note! :
(1) It would be ok to just test 1．COM1&2 TEST here. Connect COM1 and COM2 with a crossed
serial port test line, after the test succeed there will display “COM1&2 TEST OK!”, but not “ERR：
UART SEND&RECV” in the bottom of the screen.