User's Guide

Print instructions

This machine supports 58mm thermal printing paper with the specification of 57±0.5mm*Ø40mm

· Please open the paper tray by opening the lid (the top of the machine, as shown in Figure ①②). Do not open the paper bin

forcibly to prevent the gear head gear from being worn.

· According to the direction shown, put the paper into the paper bin correctly, and pull out some paper to the outside of the paper

cutter (as shown in Figure ③);

· Press firmly on the middle of the flip cover, cover the paper compartment cover, and the paper is installed (Figure ④).

note:

1. If the print content is blank, check if the direction of the paper roll is reversed;

2. For the selection of thermal paper, please refer to the certified manufacturer of the company;

3. The flip cover is not fastened, which may result in failure to print properly;

Charging and battery description

This unit only supports TypeC cable charging.

· Plug the 5V adapter into the mains outlet;

· Connect the USB cable to the machine's USB interface to charge the machine;

· Charging while the power is on, the battery icon at the top of the screen will change to the charging icon;

· Charging is in the off state, it will enter the charging mode, and the charging icon will be displayed in the middle of the screen;