User's Manual

GL100 User Manual
10
7 Device Operation
7.1 Turn on/ Turn off
• Turn on: Press the Power key at least 3 seconds and release to turn on the GL100. At
this time, Red LED 1 will light on for 2~3 seconds. Then Green LED 1 starts to blink
quickly to search the GSM network. After the GSM network is registered, it turns to be
slowly.
• Turn off: Press the Power key at least 3 seconds; Red LED 1 will light on for 2~3
seconds and then turn off, it indicates that the GL100 is turned off.
7.2 Select Operating Mode
• First, user should configure the GL100 terminal though “GL100 Manager.exe” to
realize the A-GPS position, fixed time reporting and SOS alarm functions etc.
• Press the Function Key twice within 2 sec. to ON/OFF the Geofence mode. When
Geofence mode is ON, GL100 will open GPS module and get position information
every fixed “Fix interval”, and then send the gathered position information to remote
server every fixed “Send interval”.
Note: “Fix interval” and “Send interval” will be preset by users.
• Press the key for 3 sec. to enter the SOS mode. Here Blue LED 1 will blink quickly for
searching signal and fixing location. When the GPS signal is acquired and location is
fixed, the Blue LED 1 will light less than 2 minutes, and turned off. GL100 will send the
current position information to remote server immediately. If GL100 can not acquire
the GPS signal within in 2 minutes, the Blue LED 1 will be turned off directly.