User's Manual

Smart Machine Smart Decision
SIM5320AL_User Manual_V1.01 2014-08-20
18
SPI_MOSI_DATA O
SPI (master only) master out/slave in
data
SPI_MISO_DATA I
SPI (master only) master in/slave out
data
USB
USB_VBUS
I
USB power supply input
They are compliant with
the USB 2.0 specification.
If it is unused, keep open.
USB_DP
I/O
Plus (+) line of the differential,
bi-directional USB signal to/from the
peripheral device.
USB_DM
I/O
Minus (-) line of the differential,
bi-directional USB signal to/from the
peripheral device.
Serial interface
UART_RXD
I
Receive Data
UART_RXD has been
pulled down with a 12kR
resistor to ground in the
module.
If it is unused, keep open.
UART_TXD
O
Transmit Data
UART_RTS
O
Request to send
UART_CTS
I
Clear to Send
UART_RI
O
Ring Indicator
UART_DTR
I/O
DTE get ready
UART_DCD
O
Carrier detects
I2C interface
I2C_SDA I/O I2C data
Pulled up with a 2.2kR
resistor to 2.6V internally.
If it is unused, keep open.
I2C_SCL O I2C clock output
Keypad interface
KEYPAD_0 O Bit 0 drive to the pad matrix
All Keypad pins can be
configured as GPIOs.
If it is unused, keep open.
KEYPAD_1 O Bit 1 drive to the pad matrix
KEYPAD_2 O Bit 2 drive to the pad matrix
KEYPAD_3 O Bit 3 drive to the pad matrix
KEYPAD_4 O Bit 4 drive to the pad matrix
KEYSENSE_N0 I
Bit 0 for sensing key press on pad
matrix
KEYSENSE_ N1 I
Bit 1 for sensing key press on pad
matrix
KEYSENSE_ N2 I
Bit 2 for sensing key press on pad
matrix
KEYSENSE_ N3 I
Bit 3 for sensing key press on pad
matrix
KEYSENSE_ N4 I
Bit 4 for sensing key press on pad
matrix
PCM interface
PCM_DIN/GPIO0 I
General Input PIN with module
wake/interrupt. It also can be
multiplexed as the PCM_DIN pin.
If it is unused, keep open.