User's Manual
Table Of Contents
- Contents
- Version History
- 1 Introduction
- 2 Key features
- 3 Terminal dimensions
- 4 Installation
- 5 Interface introduction
- 6 Application Interface
- 7 Electrical, Reliability and Radio Characteristics
- 8 Software/ Firmware Upgrade
- Appendix
Smart Machine Smart Decision
T5320+G_User Guide_V1.01 26 2013-04-15
Test Command Responses
AT+CWIIC=? OK
Write Command Responses
OK AT+CWIIC=
<addr>,<reg>,<data>,<len>
ERROR
Defined values
<addr>
Device address. Input format must be hex, such as 0xFF.
<reg>
Register address. Input format must be hex, such as 0xFF.
<len>
Read length. Range: 1-4; unit: byte.
<data>
Data written. Input format must be hex, such as 0xFF – 0xFFFFFFFF.
Examples
AT+CWIIC=0x0F, 0x0F, 0x1234, 2
+CWIIC: 0x1234
OK
6.8 GPS Interface
T5320+G supports both A-GPS and S-GPS, and then provides three operating modes: mobile-assisted mode,
mobile-based mode and standalone mode. A-GPS includes mobile-assisted and mobile-based mode.
6.8.1 Technical specification
Tracking sensitivity -157 dBm
Cold-start sensitivity -144 dBm
Accuracy (Open Sky) <2m (CEP50)
TTFF (Open Sky) Hot start <1s Cold start 35s（good signal）/ 100s(weak signal)
Receiver Type 16-channel, GPS L1 Frequency (1575.42MHz), C/A Code
Update rate Default 1 Hz
GPS data format NMEA-0183
GPS antenna Passive/Active antenna
6.8.2 Antenna type
.The recommended antenna specifications are showed in following table:
Table 16: antenna choosing consideration