User's Manual

Smart Machine Smart Decision
- 14 -
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.The antenna(s) used for this transmitter must be installed to provide a separation distance of at
least20 cm from all persons and must not be co-located or operating in conjunction with any other antenna
orTransmitter.
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and
2) The transmitter module may not be co-located with any other transmitter or antenna.
As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM
integrator is stillresponsible for testing their end-product for any additional compliance requirements
required with this module installed
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC authorization is no longer
considered valid and the FCC ID can not be usedon the final product. In these circumstances, the OEM
integrator will be responsible for re-evaluating the end product(including the transmitter) and obtaining
a separate FCC authorization.
End Product Labeling:
This transmitter module is authorized only for use in device where the antenna may be installed such
that 20 cm may bemaintained between the antenna and users. The final end product must be labeled in a
visible area with the following: “Contains FCC ID:UDV-20160416".
Manual Information To the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install or
remove this RF module in the user’s manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/warning as show in this manual.