User's Guide

List of packaged items
Terminal device × 1
User's Guide × 1
Charger & Adapter × 1
USB Cable × 1
Wi
-
Fi
Build-in Wi-Fi 802.11a/b/g/n(2.4G/5GNODFS)
Camera 5M AF / （0.3M FF optional）
FLASH 8GB Nand Flash
CPU basic
frequency
1.3GHZ four cores
Keys Power key, volume key
Display 5.45 inch IPS, resolution 1440×720
Operating
system
SUNMI OS 2.0 (based on Android 7.1)
Bluetooth Support of bluetooth 4.0
RAM 1GB LPDDR3
Interfaces USB Type C， Nano SIM
Printer type Thermal Printer
Printing paper
specifications
Width 58mm, maximum diameter 50mm
Touch screen Capacitive two-touch screen
Wireless data
2G：
850/1900
3G
：
B2/B4/B5
4G
：
B2/
B
4
/B
5/B7/B12/B17/B25/B26/B38/B41
Item Technical Specifications
Battery 7.6V/2580mAh
Outline
dimensions
L 219.1mm ×W 80mm ×H 17.8mm
Adapter
OUTPUT：DC5V/2A
INPUT：AC100~240V/0.3A 50/60Hz
Technical specifications
Name of parts
Circuit board
(Pb) (Hg) (Cd) (Cr(VII) (PBB) (PBDE)
Toxic and harmful substances and elements
Shell
:It indicates that the content of toxic and harmful
substances in all homogeneous materials of this part is
below the limit specified in SJ/T11363-2006.
:It indicates that the content of toxic and harmful
substances is higher than the limit specified in
SJ/T11363-2006 in at least one homogeneous material of
this part; however, the the reason why the toxic substance
of that part exceeds the limit is that there is no applicable
material to replace it currently.
For products that have reached or passed the service
years for environmental protection, they should be
recycled according to Measures for Control and
Management of Electronic Information Products and
should not be thrown away at will.
Name and content of toxic and harmful substances
contained in this product are shown in the following table
Manufacture
Shanghai Sunmi Technology Co.,Ltd.
Room 505 No.388 Song Hu Road Shanghai, China
This product can be used across EU member states.
The full text of the EU declaration DOC is available at the
following internet address：www.sunmi.com
CE certification information (SAR)
This device was tested for typical body-worn opera-
tions with the back of the handset kept 0mm away. To
maintain compliance with RF exposure requirements,
use accessories that maintain a 0mm separation
distance between the user's body and the back of the
handset. The use of belt clips, holsters and similar
accessories should not contain metallic components in
its assembly. The use of accessories that do not satisfy
these requirements may not comply with RF exposure
requirements, and should be avoided.
If you are using pacemaker, hearing aid, cochlear
implant or other device, please use the phone
according to the doctor’s advice.
PRODUCT SAFETY WARNINGS
Use responsibly. Read all instructions and safety
information before use to avoid injury.The limit
operating ambient temperature of the equipment
declared by the manufacturer is -10~45°C
Battery safety
Charge battery only at ambient temperatures ranging
from 40°C.
(1) CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the same or
equivalent type of battery recommended by the
manufacturer. Dispose of used batteries according to
battery manufacturer’s instructions.
(2) CAUTION: RISK OF EXPLOSION IF BATTERY IS
REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTIONS.
(3) CAUTION:Battery charging temperature upper limit
is 40°C.
Adapter safety
When charging, please place the device in an
environment that has a normal room temperature and
good ventilation. It is recommended to charge the
device in an environment with a temperature that
ranges from 0°C~40°C.
For altitude 2km below use only
Wi-Fi Safety
Turn Wi-Fi off in areas where Wi-Fi use is prohibited or
when it may cause interference or danger, such as in
airplanes while flying.
Declaration of Conformity
Hereby, Shanghai Sunmi Technology Co., Ltd. declares
that the Wireless data POS System(Model No.:T5930) is
in compliance with the essential requirements and other
relevant provisions of RED 2014/53/EU.
CAUTION: The device is restricted to indoor use when
operated in the European Community using frequency in
5150MHz~5250MHz to reduce the potential for
interference.
5.8G SRD receiver category：1
Technical features and characteristic
Operation Frequency Transmitted
Smart POS system
T6920
FCC Statement
Any Changes or modifications not expressly
approved by the party responsible for compliance
could void the user’s authority to operate the
equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
RF Exposure Information (SAR) :
This device meets the government's
requirements for exposure to radio waves. This
device is designed and manufactured not to
exceed the emission limits for exposure to radio
frequency (RF) energy set by the Federal
Communications Commission of the U.S.
Government.
The exposure standard for wireless devices
employs a unit of measurement known as the
Specific Absorption Rate, or SAR. The SAR limit
set by the FCC is 1.6 W/kg. *Tests for SAR are
conducted using standard operating positions
accepted by the FCC with the device
transmitting at its highest certified power level
in all tested frequency bands.
Although the SAR is determined at the highest
certified power level, the actual SAR level of
the device while operating can be well below
the maximum value. This is because the
device is designed to operate at multiple
power levels so as to use only the poser
required to reach the network. In general, the
closer you are to a wireless base station
antenna, the lower the power output.
The highest SAR value for the device as reported to worn
on the body, as described in this user guide, is 1.2W/kg
(Body-worn measurements differ among devices,
depending upon available enhancements and FCC
requirements.) While there may be differences between
the SAR levels of various devices and at various positions,
they all meet the government requirement. The FCC has
granted an Equipment Authorization for this device with
all reported SAR levels evaluated as in compliance with
the FCC RF exposure guidelines. SAR information on this
device is on file with the FCC and can be found under
the Display Grant section of http://www.fcc.gov/oet/
fccid after searching on FCC ID: 2AH25T6920.
For body worn operation, this device has been tested and
meets the FCC RF exposure .