User's Manual

UTT Technologies Chapter 7 Advanced
http://www.uttglobal.com Page 124
the priority.
Interface: It specifies an outbound interface through which the packets are forwarded
to the next hop gateway or router. The available options are LAN, WAN1, WAN2,
APClient and 3G.
Save: Click to save your changes.
Cancel: Click to revert to the last saved settings.
Back: ClicktogobacktotheStatic Route List.
7.3.4 How to Add Static Routes
To add one or more static routes, follow these steps:
Step 1 Go to the Advanced > Static Route page, and click the Add button to go to the
setup page.
Step 2 Specify the Name for the static route, and leave the Enable check box
checked.
Step 3 Specify the Destination IP, Subnet Mask,andGateway IP Address.
Step 4 Specify the Priority as required.
Step 5 Select an outbound interface from the Interface drop-down list as required.
For example, if you want to add a static rou te for the network 192.168.1.0/24 pointing to
192.168.1.254, please choose LAN as the outbound interface. The following figure shows
the detailed settings.
Figure 7-20 Static Route Settings - Example