User's Manual

UTT Technologies Chapter 11 System Administration
http://www.uttglobal.com Page 177
11.5 Remote Access
This section describes the Administration > Remote Access page. In this page, you can
enable HTTP remote management, which allows you to access the Wireless Router’s
Web UI from anywhere over the Internet.
Figure 11-9 Remote Access Settings
Enable HTTP: It allows you to enable or disable HTTP remote management. Select
this check box to enable HTTP remote management. To access the Wireless
Router’s Web UI over the Internet, you should enter http:// and the Wireless Router's
WAN IP address, followed by a colon and the port number. For example, if the WAN
IP address is 218.21.31.3 and port number is 8081, please enter
http://218.21.31.3:8081
in your browser’s address bar.
Remote Management Port: It specifies the port number that will be open to outside
access.
T
he default value is 8081.
Interface: It specifies the interface on which the HTTP remote management is
enabled. Here you can select only one interface. To enable HTTP remote
management on multiple interfaces at the same time, you need to go to the
Advanced > NAT&DMZ > Port Forwarding page to create port forwarding entry(s)
for the other interface(s).
Save: Click to save your changes.
Cancel: Click to revert to the last saved settings.
Note
1. To ensure security, it is strongly recommended that you don’t enable HTTP remote
management unless necessary.
2. After you enable the HTTP remote management, the system will automatically create
a port forwarding entry whose name is admin.YoucangototheAdvanced >
NAT&DMZ > Port Forwarding page to view it in the Port Forwarding List.