User's Manual

UTT Technologies Appendix B FAQ
http://www.uttglobal.com Page
191
Figure B-0- 2 Viewing PPPoE Connection Status in the Internet Connection List (Continue)
Step 8 Configure the local computers according to the steps described in Appendix A
How to Configure Your PC.
2. How to connect the Wireless Router to the Internet
using Static IP?
Step 1 Please make sure the Internet connection is normal. You may use your PC to
test.
Step 2 Connect a network cable from the network device provided by your ISP to a
WAN port of the Wireless Router.
Step 3 Configure the Static IP Internet connection related parameters in the Start >
Setup Wizard or the Network > WAN page.
Step 4 After the Static IP connection is established successfully, you can view its
configuratio n and status information in the Internet Connection List on the
Network > WAN page.
Step 5 Configure the local computers according to the steps described in Appendix A
How to Configure Your PC.
3. How to connect the Wireless Router to the Internet
using DHCP?
Step 1 Please make sure the Internet connection is normal. You may use your PC to
test.
Step 2 Connect a network cable from the network device provided by your ISP to a
WAN port of the Wireless Router.