User's Manual

UTT Technologies Chapter 2 Hardware Installation
http://www.uttglobal.com Page 13
Chapter 2 Hardware Installation
2.1 Physical Characteristics
2.1 .1 Fro nt Pan e l
As shown in Figure 2-1, the LEDs are located on the front panel of the Wireless Router.
The LEDs indicate the status of the system and each port. Table 2- 1 describes these
LEDs.
Figure 2-1 Front Panel of the Wireless Router
LED Full Name State Description
PWR Power LED
On The Wireless Router is powered on.
Off The Wireless Router is powered off.
SYS System LED
Blinking The system is operating properl y.
On The system is not operating properly.
Off The system is not operating properly.
USB
3G USB Modem
Status LED
On A 3G USB modem is connected to the USB port.
Off No 3G USB modem is connected.
WLAN
Wireless LAN
Status LED
On The wireless function is enabled.
Blinking
The Wireless Router is sending or receiving data over the
wireless network.