User's Manual

UTT Technologies Chapter 5 Network
http://www.uttglobal.com Page
49
5.1.2.2 3G Internet Connection Settings
To configure a 3G Internet connection, select 3G from the Interface drop-down list. Then
the following page will be shown.
Figure 5-9 3G Internet Connection Settings
Interface: It specifies the name of the WAN interface. Here please select 3G.
ISP Policy and Update Policy: Refer to Section 5.1.2.1.1 Static IP Internet
Connection for detailed information.
3G USB Modem, ISP, Authentication Method, PIN Code, APN, Dial Number,
User Name,andPassword: Refer to Section 3.3.3.2 3G Internet Connection
Settings for detailed information.
Save: Click to save your changes.
Cancel: Click to revert to the last saved settings.
Note
It is strongly recommended that you configure only the 3G USB Modem and ISP of
the 3G Internet connection, and leave the other parameters at their default values. If
necessary, please follow your ISP’s instructions to change them. After you click the
Save button, the Wireless Router will start to dial. It may take a minute or so,
depending on the model of your 3G USB modem. Please click the Refresh button to
view the 3G connection status. If it fails to dial, please try to pull out and insert the 3G
USB modem again or restart the Wireless Router.