User's Manual

UTT Technologies Chapter 5 Network
http://www.uttglobal.com Page
50
5.1.3 MAC Address Clone
Some ISPs register the MAC address of your network device (usually a computer) when
your account is first opened, and they will only accept traf fic from that MAC address. With
MAC address clone feature, you may assign the registered MAC address to the Wireless
Router’s external interface if you don’t want to re-register the MAC address with your ISP.
To configure MAC address clone, go to the Network > WAN page, and then select the
MAC Address Clone tab to go to the setup page shown in Figure 5-10 MAC Address
CloneFigure 5-10. In this page, you can change the MAC address of each exte rnal
interface (WAN1, W AN2, or APClient interface) as required.
Figure 5-10 MAC Address Clone
WAN1 MAC Address: It specifies the MAC address of the Wireless Router’s WAN1
interface.
WAN2 MAC Address: It specifies the MAC address of the Wireless Router’s WAN2
interface.
APClient MAC Address: It specifies the MAC address of the Wireless Router’s
APClient interface.
Save: Click to save your changes.
Cancel: Click to revert to the last saved settings.