User's Manual

UTT Technologies Chapter 5 Network
http://www.uttglobal.com Page
56
Figure 5-15 Connection Detection Settings
Interface: It indicates the name of the WAN interface. It is non-editable.
Detection Interval: It specifies the time interval at which the Wireless Router
periodically sends detection packets, one packet at a time. It must be between 1 and
60 seconds, or 0. The default value is 0, which means that connection detection is
disabled on the Internet connection.
Retry Times: It specifies the number of retries per detection period. The default value
is 3.
Detection Target IP: It specifies the IP address of a detection target device. The
Wireless Router will monitor the Internet connection by sending the detection packets
to the detection target IP address.
Bandwidth: It specifies the Internet connection’s bandwidth, which is provided by
your ISP.
Start Internal IP and End Internal IP: They specify a range of internal IP addresses.
The local computers within the specified range will preferentially use the Internet
connection. Refer to Section 5.2.1.1 Internet Connection Detection Mechanism
for more information.
Save: Click to save your changes.
Cancel: Click to revert to the last saved settings.
Back: ClicktogobacktotheLoad Balancing List page.
Note
The Detection Target IP, Detection Interval,andRetry Times are connection
detection related parameters. Please refer to Section 5.2.1.1 Internet Connection
Detection Mechanism for more information.