User's Manual

www.uttlogin.com
www.uttlogin.com
www.uttlogin.com
http://www.uttlogin.com/-Microsoft Internet...
www.uttlogin.com
http://www.uttlogin.com/-Microsoft Internet...
PPPoE Connection: Enter your PPPoE
username and password offered by your
ISP.
Dynamic IP: ISP does not provide any
data, you can access Internet without any
username or IP address settings.
Static IP: Enter your IP Address, Subnet
Mask, Gateway IP Address and DNS Address
offered by your ISP.
Configure your Internet settings and click “Save”.
Enter wireless password that has been set
in the pop-up screen and click “Connect”.
Enter wireless password that has been
set in the pop-up screen and click “OK”.
Click icon in the task bar. Please
choose the wireless network you are
going to connect in the pop-up list and
click “Connect”.
Click “Start Control Panel Network
and Connection Wireless Network
Connection”, make sure wireless
network connection is enabled.
Click “Start Control Panel Network
and Connection Network and sharing
centre Change Adapter Settings”,
make sure wireless network connection
is enabled.
Click icon in the task bar. Please
choose the wireless network you are
going to connect in the pop-up list and
click “Connect”.
Please click the wireless
network you are going to
connect.
Click “Connect to the network”.Open the WLAN, and click network
list.
Click “System setup”.
Please click the wireless
network you are going to
connect.
Open the WLAN.Click “ WLAN”.
Click “setup”.
If you need to configure 5G wireless network,
you can click “Save” and continue to configure
5G Wireless network (only for dual-band
wireless router.
Congigure wireless settings (2.4G)
and click “Save”.
Configuration completed.
address field of your browser. Click “Yes to configure
the router now”.