Data Sheet
Table Of Contents
- 1 Module Overview
- 1.1 Features
- 1.2 Description
- 1.3 Applications
- CONTENTS
- LIST OF FIGURES
- LIST OF TABLES
- HISTORY
- 2 Hardware Introduction
- 2.1 Pin Layout
- 2.2 Pin Description
- 2.3 Physical Dimensions
- 2.4 Ordering Information
- 3 Dimensions of External Antenna Connector
- 4 Electrical Characteristics
- 4.1 Absolute Maximum Ratings
- 4.2 Recommended Operating Conditions
- 4.3 ESD
- 4.4 WiFi/BLE RF Standards
- 5 Peripheral Schematics
- 6 Product Handling
- 6.1 Reflow Profile
- 6.2 Storage Conditions
- 6.3 Device Handling Instruction (Module IC SMT Prepara
- 7 Contact Information
X-C13SG-0
802.11bgn and BLE SoC
Shanghai ChipFresh Internet of Things Technology Co., Ltd
15
Shelf life in sealed bag: 12 months, at <30
℃
and <60% relative humidity (RH).
Recommend to store at
≦
10% RH with vacuum packing.
The module is rated at the moisture sensitivity level (MSL) of 3.
6.3
Device Handling Instruction (Module IC SMT Preparation)
Baked required with 24 hours at 125+-5
℃
before rework process.
After bag is opened, devices that will be re-baked required after last baked with window time
168 hours.
Recommend to oven bake with N2 supplied
Recommend end to reflow oven with N2 supplied
If SMT process needs twice reflow:
(1) Top side SMT and reflow (2) Bottom side SMT and reflow
Case 1: Wifi module mounted on top side. Need to bake when bottom side process over 168
hours window time, no need to bake within 168 hours
Case 2: Wifi module mounted on bottom side, follow normal bake rule before process Note:
Window time means from last bake end to next reflow start that has 168 hours space.
6.4 FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. Changes or modifications not
expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Important Note:
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator and
your body.