Instruction Manual

DASHER™
RC STUNT CAR | Instruction Manual
REMOTE CONTROL
1. Loosen and remove the lock screw located on the rear of your remote control and remove the
battery compartment lid.
2. Insert 2 AA batteries according to the polarity information located in the compartment; make
sure the (+) and (-) poles of each battery are positioned correctly.
3. Replace the battery compartment door and screw; tighten screw completely to lock in place.
CAR
1. Loosen and take out the lock screw located on the rear of your Dasher and remove the battery
compartment lid.
2. Insert 3 AA batteries according to the polarity information located in the comp
artment; make
sure the (+) and (-) poles of each battery are positioned correctly.
3. Replace the battery compartment door and screw; tighten screw completely to lock in place.
1. The Dasher is activated by moving the red toggle switch located on the bottom of the vehicle to
the ON position. To deactivate, move the switch to the OFF position
2. Your vehicle is paired to a remote control of matching frequency. Your remote control will be
labeled with the corresponding frequency.
3. Drive the car by operating the white buttons on your remote control (Figure A).
SPINNING STUNT MOVES – Your Dasher is capable of any
number of spins, turns, wheelies and
other stunts. To do so, simply move your Dasher backward or forwards while also pushing one of
the buttons on the right side of the remote that make the front axle twist. Different combinations of
pushing these buttons will create different tricks! (Figure B)
IMPORTANT
Dasher’s are available in two colors, red & green. To allow for simultaneous play, each vehicle is
paired to a remote control of matching frequency. The red Dasher is 27Mhz and the green car is
49Mhz – your remote controls will be labeled with the corresponding frequencies.
BATTERY INSTALLATION
FIGURE B
Please read this instruction manual carefully before using.
• For Ages 3+
• Adult guidance is strongly recommended.
Wheelie Stunt
FIGURE A
OPERATION