How-To Guide

1:20

NO.S787E

NO.787E 21.7x17x9.3cm

500 mAh

1:20

500 mAh

2. Install 2 *1.5V AA batteries with the correct polarity (+/-)

as shown inside the battery compartment.

3. Close the battery cover.

FOR TRANSMITTER:

1.Remove the battery lid.

1. Switch ON the vehicle and transmitter.

2. Remember to switch OFF the vehicle and transmitter when you are done driving.

HOW TO DRIVE THE RC VEHICLE:

Transmitter:

Power

switch

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions,

may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception,

which

can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which

the

receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for

compliance could

void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference

that may cause

undesired operation.