Instructions / Assembly

SH
PE
PRODUCTS
1. Place the window well cover over the window well and push it
tight against the exterior of the house. (FIGURE A)
2. Center the cover on your well and mark the locations where the
clips will attach. (FIGURE B)
3. Remove the cover from your well and drill a 3/16” hole at each
marked location. (FIGURE C)
4. Mount the clips to your cover using the provided cap nuts and
bolts provided and tighten the screw until you’ve reached your
desired tension. (FIGURE D)
5. Snap the window well cover onto the rim of the window well.
(FIGURE E)
Tension Spring Clips
3/16” Bolts
3/16” Cap Nuts
Clean your window well cover with a mild solution detergent and
water. Use of harsh chemicals or solvents may damage plastic and
void warranty.
FIGURE A
FIGURE B
FIGURE C
FIGURE D
FIGURE E
Spring Clip Hardware
Installation Instructions
What You Need
Installation
Cleaning Instructions
www.shapeproducts.com
5205 Freitag Drive Menomonie, WI 54751 | Phone: [phone] | Email: [e-mail]
For warranty information, visit our website