Installation Guide

CUSTOM WINDOW WELL COVER
SPRING CLIP INSTALLATION INSTRUCTIONS
INSTALLATION
1. Place the Window Well Cover over the window well and push it tight
against the house.
NOTE: If the cover doesn’t fit symmetrically, the steel well may be bent out of
shape. Use a sledgehammer to tap the well to allow the cover to fit. (FIGURE A)
2. Center the cover on your well and mark the locations where the clips will
attach. (FIGURE B)
3. Remove the cover from your well and drill a 3/16” hole at each marked
location. (FIGURE C)
4. Mount the clips to your cover using the cap nuts and bolts provided and
tighten the screw until there is about 1/4” space in the spring clip. (FIGURE
D)
5. Snap Window Well Cover onto the rim of the window well. (FIGURE E & F)
WHAT YOU NEED
Tension Spring Clips
3/16” Bolts
3/16” Cap Nuts
SH
PE
PRODUCTS
5205 Freitag Drive Menomonie, WI 54751 • 715-232-0495 • shapeproducts.com
FIGURE A
FIGURE B
FIGURE C
FIGURE D
FIGURE E
FIGURE F
CLEANING INSTRUCTIONS
Clean your window well cover with a mild solution detergent and
water. Use of harsh chemicals or solvents may damage plastic and void
warranty.