User`s manual

reel-carrier without any hindrances or preventing the entrainment of the wire by the extruder. For

this reason, the printer may not be placed on a shelf that is at least 35 cm free space around the rear

or side.

Assembling the reel-carrier

The two sides of the triangle shaped and coils are identical; start with the screw on a nut on one side

of the threaded bar, leaving 15mm of thread and repeat on the other side. Now insert the threaded

bar on the shoulder using the hole on the top of the triangle and x it with the nut. Do not overtighten

to avoid breaking the plexiglass. Insert the reel and attach the second shoulder. Place the door coils

behind or sideways into the printer recalling that the wire must carry out unhindered and in the di-

rection of the extruder.

Unlocking the extruder

To avoid damage during transport, the blocking of the extruder is secured with clamps. The clamps

must be carefully cut and removed to allow the extruder to move freely. DO NOT feed the printer until

you have done this step otherwise you will damage the motors and mechanics.

Remove all packaging inside the machine.

Parking second extruder

If you have purchased a NG with double extruders this operation is crucial to the success of your

prints; loosen the allen screw on the plate that connects the two carriers, we can move in parking

position (to the le) the second extruder, which will be coated in the le shoulder by a magnet. This

operation is essential to perform calibration.