User`s manual

Main Menu

Disable engines

Auto Home

Preheats RX

Preheats LX

Cool

Move Axes

Calib. Printing bed Auto

Calib. Printing bed Man.

Change Wire RX

Change Wire SX

“Adapt” Menu

The item appears only when the printer is performing a job playing the G-Code, just by printing this

article appears as rst in the list when you press the knob.

Main Menu

Speed

Nozzle

Nozzle 2

Printing bed

Fan

Stream

Change Filament

Inside there is an additional menu that allows us to vary the overall printing speed, expressed as a

percentage and identical to the present as a feed rate information screen (velocity is the parameter

which is varied by rotating the knob from the screen information). Below the set temperature for

the nozzle (two nozzles in the case of dual-extruder printer): the value is in degrees Celsius and any

change must be conrmed by pressing the menu knob. Same thing for the heated stage.

The next item is the fan speed, adjustable from 0 to 255; with very low values the fan may not even

start to turn.

The stream value is relative to the percentage increment or decrement in material ow in the extru-

sion phase: slicing soware calculates exactly how the material is extruded to create individual lay-

ers, but unforeseen changes or not declared in wire diameter than the given value as a parameter

to the slicing could then request compensation and this entry serves for this purpose. A value of 100

corresponds to any variation of the ow of material, values less than 100 reduces the contribution of