Instructions

Care Instructions

When and how do I clean the filters?

Filters may need to be cleaned if the vacuum stops picking up dirt, if airflow is restricted, or if

you notice lighter or no suction. For optimal performance, clean filters regularly. Between

cleanings, lightly tap filters over a trash receptacle to remove dust and debris as needed.

Rinse the pre-motor foam and felt filters every 3 months, or as needed.

 First, remove the dust cup to access the pre-motor filters.

 Slide up the release latches on both sides of the dust cup handle. Lift the dust cup up and

away from the pod.

 Remove the foam and felt filters.

 Rinse both filters with water only.

 Allow filters to air-dry completely (at least 24 hours) before reinstalling.

 Once dry, install the felt filter first, followed by the foam filter.

 Reinstall the dust cup by placing the bottom of the dust cup into the pod and then tilting

until it clicks into place.

Rinse the post-motor HEPA filter every 12 months, or as needed.

 Pull the latch under the HEPA filter cover and lift off the cover. This is located

underneath the Lift-Away logo on the bottom of the pod.

 Remove the HEPA filter, press the side latch

 Rinse with water only.

 Allow filter to air-dry completely (at least 24 hours) before reinstalling.

 Once dry, reinstall the HEPA filter.

 Reattach the HEPA filter cover until it clicks into place.

PAGE 1
Care Instructions When and how do I clean the filters? Filters may need to be cleaned if the vacuum stops picking up dirt, if airflow is restricted, or if you notice lighter or no suction. For optimal performance, clean filters regularly. Between cleanings, lightly tap filters over a trash receptacle to remove dust and debris as needed. Rinse the pre-motor foam and felt filters every 3 months, or as needed.        First, remove the dust cup to access the pre-motor filters.