Operating instructions
96-718, 97-721, 97-723 • REV. 8/05a
OPERATOR’S MANUAL 
PRESSURE WASHER  
12
SHUTTING 
DOWN 
AND CLEAN-UP
STEP 1: Remove detergent suc tion 
tube from container and insert into 
one gallon of fresh water. Slide noz zle 
for ward for low pressure or to con nect 
black detergent nozzle. Pull trig ger on 
spray gun and si phon water for one 
minute.
STEP 2: Turn engine switch to "OFF" 
position.
STEP 3: Turn off water 
sup ply.
STEP 5: Disconnect the garden 
hose from the water inlet on the 
machine.
STEP 6: Disconnect the high 
pres sure hose from the dis-
charge nipple.
STEP 7: En gage 
the spray gun safe ty 
lock.
STEP 4: Press 
trig ger to re lease 
wa ter pres sure.
CAUTION: Al ways store your pressure washer in a 
lo ca tion where the temperature will not fall be low 
32°F (0°C). The pump in this machine is sus cep ti ble 
to permanent dam age if fro zen. FREEZE DAM AGE 
IS NOT COV ERED BY WARRANTY.
  1.  Stop the pressure washer, squeeze spray gun trig-
 ger to release pressure.
 2. 
Detach water supply hose and high pressure hose.
  3. Turn on the machine for a few seconds, until re-
 main ing water exits. Turn engine off im me di ate ly.
 4. Drain the gas and oil from the engine.
 5. 
Do not allow high pressure hose to become kinked.
  6. Store the machine and accessories in a room which 
does not reach freezing temperatures.
CAUTION: Fail ure to follow the above di rec tions will 
result in dam age to your pres sure washer.
When the pres sure washer is not being operated or is 
be ing stored for more than one month, follow these 
in struc tions:
 1. Replenish engine oil to up per level.
 2. Drain gas o line from fuel tank, fuel line, fuel valve 
and carburetor.
  3. Pour about one teaspoon of engine oil through 
the spark plug hole, pull the starter grip several 
times and re place the plug. Then pull the starter 
grip slow ly until you feel increased pressure which 
indicates the pis ton is on its compression stroke and 
leave it in that position. This closes both the intake 
and ex haust valves to prevent rusting of cylinder.
  4. Cover the pressure washer and store in a clean, dry 
place that is well ventilated away from open fl ame  
or sparks. NOTE: The use of a fuel additive, such 
as STA-BIL
®
, or an equivalent, will minimize the 
for mu la tion of fuel deposits during shortage. Such 
ad di tives may be added to the gasoline in the fuel 
tank of the engine, or to the gasoline in a storage 
con tain er.
After Extended Storage
CAUTION: Prior to restarting, thaw out any 
pos si ble ice from pressure washer hos es, 
spray gun or wand.
Engine Maintenance
During the winter months, rare atmospheric conditions 
may develop which will cause an icing con di tion in the 
car bu re tor. If this de vel ops, the engine may run rough, 
lose power and may stall. This temporary condition can 
be overcome by defl ecting some of the hot air from the 
en gine over the carburetor area.  NOTE: Refer to the 
en gine man u fac tur er's manual for service and main te -
nance of the engine.
STORAGE
On-Off
Switch
 Water 
Inlet
Discharge
Nipple
Safety 
Latch










