Operating instructions

96-718, 97-721, 97-722, 97-723 • REV. 4/04
OPERATOR’S MANUAL
PRESSURE WASHER
8
ASSEMBLY INSTRUCTIONS
STEP 1: Attach the high pres-
sure hose to the spray gun using
teflon tape on hose threads.
STEP 3: Release the coupler
collar and push the nozzle
until the collar clicks. Pull the
nozzle to make sure it is
seated properly.
STEP 5: Connect the high pressure
hose to the pump discharge fitting.
Push coupler collar forward until
secure.
STEP 2: Pull the spring-loaded
collar of the wand coupler back
to insert your choice of pressure
nozzle.
STEP 6: Connect garden hose to
the cold water source.
STEP 7: Check inlet filters, remove
debris, then connect garden hose to
pump water inlet. CAUTION: Do not
run the pump without water or
pump damage will result.
Safety
Latch
Spray
Gun
High Pressure
Hose
Wand
Coupler
Pressure
Nozzle
Pressure
Nozzle
Wand
Coupler
Wand
Collar
Discharge
Fitting
High Pressure Hose
Cold
Water
Source
Garden
Hose
Pump
Water Inlet
Garden
Hose
Coupler Collar
Dipstick
STEP 4: Remove shipping cap and
install oil dipstick. Check pump oil
level by using dipstick or observe oil
level in oil window (if equipped). Use
30 wt. non detergent oil.