OWNER’S GUIDE S3101UKM S3101UKM_11_IB_ENG_120906_1.
IMPORTANT SAFETY INSTRUCTIONS For Household Use Only WHEN USING YOUR SHARK STEAM MOP, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING: WARNING: READ ALL INSTRUCTIONS BEFORE USING YOUR STEAM MOP. DANGER OF SCALDING. Please use caution when using the steam mop. The steam emitted from the openings is very hot. WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY: 1. Use the system only for its intended use. 2. DO NOT use outdoors. 3.
10. DO NOT pull or carry by power cord, use power cord as handle, close a door on the power cord, or pull the power cord around sharp edges or corners. Keep power cord away from heated surfaces. 11. DO NOT unplug by pulling on power cord. To unplug, grasp the plug not the power cord. Do not use extension cords or outlets with inadequate current carrying capacity. 12. DO NOT put any objects into openings. Do not use with any opening blocked. 13. DO NOT put hands or feet under the steam mop.
Quick Start 2 1 3 1 2 ASSEMBLE Fit together the extension tubes as shown in the illustration. See page 2 for more detailed assembly instructions. Place the microfibre cleaning cloth underneath the mop head, with quick fastener strips facing up. Simply press the pad to the mop to attach it. 3 FILL Remove the cap to fill the Water Tank. Using the filling flask and funnel, fill the tank, keeping the water under the “MAX FILL” line. Don’t forget to replace the cap.
Quick Start 4 PRIME STEAM 5 Plug in the mop. Wait approximately 30 seconds for the unit to heat up and the steam to be ready. Push the handle toward the mop head in a pumping motion. To prime simply pump the handle 10-15 times to generate the steam. QUICK TIP: Customise steam output by slow or fast mopping with a forward and backward motion. HELP LINE: 0844 873 0728 S3101UKM_11_IB_ENG_120906_1.
This appliance complies with the WEEE-Directive 2002/96/EC on the disposal of electrical and electronic equipment (WEEE). This appliance complies with the European directives for electromagnetic compatibility (EMC) 2004/108/EC and its revisions, as well as Low Voltage Directive (LVD) 2006/95/EC and its revisions. This marking indicates that this product should not be disposed with other household wastes throughout the EU.
Contents Thank you for purchasing the Shark Steam Mop. GETTING STARTED 2 USING YOUR STEAM MOP 6 CARE OF YOUR STEAM MOP 8 TROUBLESHOOTING 9 1 S3101UKM_11_IB_ENG_120906_1.
Getting Started When assembling your steam mop there may be a little water in or around the water tank. This is because we test all our steam mops 100% before you buy them, so you get a quality Shark® Steam Mop. a c b e d FIRST THINGS FIRST, YOU NEED TO KNOW WHAT’S IN THE BOX YOU JUST OPENED: a Upper Extension Tube b Lower Extension Tube (Telescopic) c Steam Mop Base d 2 Microfibre Pads YOUR SHARK STEAM MOP IS EASY TO ASSEMBLE 1 First remove all the parts from the package.
3 Always attach the microfibre cleaning pad to the mop head or you may scratch your floor surface. Note: Plug supplied may vary depending on region. 3 Insert the pieces you assembled in Step 2 into the pump actuator (the tube that leads to the tank). Push the extension tube assembly and pump actuator together in until you hear it click into place. Insert cord into cord clip on the shaft of the steam-mop.
Getting Started 1 PLACING THE MICROFIBRE PAD 1 Place the microfibre cleaning cloth underneath the mop head, with the quick fastener strips facing up. Simply press the pad on to the Steam Mop. IMPORTANT: Make sure you only add water to the tank. Chemicals or cleaning solution may damage the appliance and could be unsafe for you and your family. 4 NOTE: Don’t be alarmed if the first time you use your Steam Mop, you notice water inside the water tank or drops of water in the packaging.
The water tank cap has an arrow to indicate the locked and unlocked position. 1 FILLING THE WATER TANK IMPORTANT: Before you fill up the tank, make sure your Steam Mop is unplugged from the wall. 1 First, remove the water tank cap by turning it counter clockwise to the unlocked position. See illustration for a visual explanation. Note: Plug supplied may vary depending on region.
Using Your Steam Mop 1 IMPORTANT: Your Steam Mop needs water to make steam! Never use your Steam Mop without water in the tank. Sweep or vacuum your floors before using your Steam Mop. Your Steam Mop was designed to get rid of stuck-on gunk, grime, paw/ footprints and it will do a better job if yesterday’s cereal crumbs aren’t in the way. 6 Now comes the part you’ve been waiting for – it’s time to use your steam mop.
2 When your Steam Mop stops steaming, it could be out of water. Unplug the power cord from the electrical outlet and refill the water tank at anytime. 3 2 It takes about 30 seconds for the steam to get going. Now pump the handle a few times to prime the pump and activate steam. 3 Mop with a forward and backward motion to customise steam output automatically.
Care of Your Steam Mop Always remove the microfibre cleaning pad from the Steam Mop head when you store your Steam Mop to avoid damage to your floors. 40° KEEPING YOUR MICROFIBRE CLEANING PAD AS GOOD AS NEW Your steam activated microfibre cleaning pad works wonders for you, so return the favour by giving it the care it deserves. 1 Wash pad in warm water. Wash separately from other laundry. Only use liquid detergent (no powder detergent). Don’t use any fabric softeners. Line dry. Do not tumble dry.
Trouble Shooting PROBLEM The Steam Mop will not turn-on. POSSIBLE REASONS & SOLUTIONS Your steam-mop should be securely plugged into a 220-240V electrical outlet only. Check your fuse or breaker. Steam Mop will not make steam. Is there water in the water tank? If not, add water to your Steam Mop following instructions. Steam Mop leaves water on the floor. Is your microfibre cleaning pad too wet? Why don’t you unplug your Steam Mop and change the microfibre cleaning pad.
The After Sales Division Mexborough South Yorkshire England S64 8AJ Technical Details: Model number: S3101UKM 11 Input: 1550 Watts Main unit voltage: 220-240V~, 50/60 Hz COPYRIGHT© EURO-PRO OPERATING LLC 2012 PRINTED IN CHINA S3101UKM.E.120906.1 Illustrations may differ from actual product. S3101UKM_11_IB_ENG_120906_1.indd 10 Not to be disposed of with other household waste.