OWNER’S MANUAL Model GI477/GI477R 120V., 60 Hz., 1500 Watts EURO-PRO Operating LLC U.S.: 94 Main Mill Street, Door 16 Canadá : 4400, Bois-Franc Plattsburgh, NY 12901 St-Laurent, QC H4S 1A7 Tel. : 1 (800) 798-7398 www.sharkcompany.
IMPORTANT SAFETY INSTRUCTIONS When using your iron, basic safety precautions should always be followed, including the following: 1. Read all instructions carefully. 2. Use iron only for its intended use. 3. To protect against risk of electrical shock, do not immerse the iron in water or other liquids. 4. Never yank cord to disconnect from outlet. Grasp plug and pull to disconnect. 5. Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. 6.
TROUBLESHOOTING PROBLEM Iron does not heat Some odor or small particles come out of steam vents of new iron Iron does not steam Water droplets coming from steam vents POSSIBLE REASONS & SOLUTIONS • Iron should be plugged into a 120V AC electrical outlet only. Make sure that the plug is securely in the socket. • Temperature setting too low. Select a higher fabric setting. • This is normal.
FEATURES OF SHARK RETRACTORTM IRON LED Display Panel 3 2 1 IRONING CHART NOTE: Always refer to the garment care tag for ironing instructions. Before starting to iron delicate fabrics, it is best to first test the temperature of the iron on a hem or an inside seam. DIRECTIONS ON LABEL Burst of steam provides extra, sudden bursts of steam which aid in removing stubborn wrinkles from fabrics such as denim, cotton or linen. FABRIC 7.
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS Emptying the Iron This appliance is for HOUSEHOLD USE ONLY and may be plugged into any 120V AC polarized electrical outlet. Do not use any other type of outlet. 1. Always empty iron after each use. 2. When finished using the iron, turn the variable steam control to “0” and press the electronic temperature control button until the power light is lit. 3. Unplug the iron from the electrical outlet. 4.
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS Selecting Iron Temperatures 4. Place the iron on its heel on a stable, protected surface and allow the iron to heat for approximately two (2) minutes or until the temperature settings on the right side of the LED display panel have stopped flashing. 5. Turn the variable steam control dial to the right to increase the amount of steam. When using extra steam, the iron uses more water and it may be necessary to fill the water tank more often. (Fig.