Use and Care Manual

MESH DUST FILTER MAINTENANCE
Checking the Mesh Dust Filters:
When it’s time to check your dust filters for maintenance, the front display will show the following screen with a pulsing red ring:
Cleaning the Mesh Dust Filters:
For best results, check both dust filters for debris when prompted on the front display.
If maintenance is required, be sure to KEEP THE AIR PURIFIER PLUGGED IN and running, and complete the following steps:
Gently slide up the filters to remove
them. Check the screens for dust and
debris buildup.
Use a vacuum cleaner on low speed with
a soft brush attachment OR a cloth/towel
to remove debris from the mesh screen.
DO NOT use abrasive chemical cleaners.
If additional cleaning is required, rinse the
mesh dust filters with room temperature tap
water. Be sure to completely dry the screen
for 12 hours before re-installing. DO NOT
USE the air purifier when mesh filers are
wet to prevent damaging the HEPA filter.
Gently reinsert the mesh dust filters into the
slots on the sides of the air purifier. Be sure
to push each dust filter into place until it is
flush with the air purifier body.
Once both mesh dust filters have been
cleaned and reinstalled, the air purifier will
recalibrate and begin to analyze air quality,
indicated by the rotating lights.
1. LOCATE AND REMOVE
MESH DUST FILTER
4. REINSTALL MESH DUST FILTERS
2. CLEAN DUST FILTER
5. RECALIBRATION
3. ADDIITONAL CLEANING
(NOT REQUIRED)
Note: The NeverChange HEPA Filter Technology™ allows up to 5 years* of use out of a single HEPA filter.
*Tested to GB/T18801-2015 P.CCM, based on 50% CADR declined, 300 sq. ft. cleaning area and 12 hours daily operation on MAX fan speed.
Note: To manually re-set the Check
Dust Filters indicator, press and hold
the filter icon on the top control panel
for 1.5 seconds.