CORDLESS PRO MultiFLEX® Vacuum with Self-Cleaning Brushroll IZ600 Series OWNER’S GUIDE POWERFINS™
IMPORTANT SAFETY INSTRUCTIONS FOR HOUSEHOLD USE ONLY WARNING When using an electrical appliance, to reduce the risk of fire, electric shock, injury, or property damage, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM: 1. This vacuum consists of a motorized nozzle, wand, and handheld vacuum. These components contain electrical connections, electrical wiring, and moving parts that potentially present risk to the user.
ASSEMBLY LI-ION BATTERY The Lithium Ion Power Pack battery does not come fully charged. Prior to first use, charge completely. During first use, run the battery down until it is completely out of power. This will condition the battery. 1. Insert Wand into Floor Nozzle. 2. Insert Handheld Vacuum into wand. LED BATTERY POWER AND CHARGING INDICATORS For proper operation, ensure all components are completely connected and clicked into place.
SETTINGS CHARGING THE BATTERY USING THE LI-ION CHARGER POWER ON/OFF LI-ION CHARGER Plug the Li-Ion Charger into a wall outlet. IN HANDHELD VACUUM To charge the battery inside the handheld vacuum, connect the charger to an electrical outlet, then insert the charger plug into the port below the handle on the handheld vacuum. Press power button to turn vacuum on or off. NOTE: The unit will not turn on if the charger is connected. Unplug the charger before turning on vacuum power.
CLEANING MODES USING THE MULTIFLEX® WAND UPRIGHT MODE To clean floors, step on floor nozzle and tilt handheld vacuum back. NOTE: Brushrolls will only engage when the handheld vacuum is tilted back. Press the unlock latch on the back of the wand, then adjust the angle. Adjust the wand to a lower angle to easily clean under furniture. MULTIFLEX STORAGE (Click) ABOVE-FLOOR HANDHELD Press the wand release button and lift the handheld vacuum off the wand.
MAINTAINING YOUR VACUUM MAINTAINING YOUR VACUUM EMPTYING THE DUST CUP CLEANING THE FILTERS 1 2 Regularly rinse and replace the filters to maintain your vacuum’s suction power. To clean filters, rinse them with water only. Allow all filters to air-dry completely before reinstalling to prevent liquid from being drawn into electric parts. Clean the pre-motor filters at least once a month and post-motor HEPA filter at least once a year. Tap off loose dirt between washes when needed.
MAINTAINING YOUR VACUUM MAINTAINING YOUR VACUUM FLOOR NOZZLE CHECKING FOR BLOCKAGES If any hair is wrapped around the brushroll, continue cleaning using the Carpet setting on a bare floor surface, a low-pile carpet, or a small area rug. If some fibers remain wrapped around the brushroll after continued use, carefully remove them. If you run over a hard or sharp object or notice a change in noise while vacuuming, check the floor nozzle for blockages.
TROUBLESHOOTING GUIDE ADDITIONAL ACCESSORIES AVAILABLE ON SHARKACCESSORIES.COM WARNING: To reduce the risk of shock and unintended operation, turn off power and remove the Lithium Ion Power Pack battery before servicing. Vacuum is not picking up debris. No suction or light suction. Filter icon on handheld vacuum control panel is red. (Refer to Checking for Blockages section for more information.) • Check filters to see if they need cleaning.
FIVE (5) YEAR LIMITED WARRANTY TWO (2) YEAR LIMITED BATTERY WARRANTY The Five (5) Year Limited Warranty applies to purchases made from authorized retailers of SharkNinja Operating LLC. Warranty coverage applies to the original owner and to the original product only and is not transferable. The Two (2) Year VIP Limited Warranty applies to purchases made from authorized retailers of SharkNinja Operating LLC.
NOTES REGISTER YOUR PURCHASE sharkclean.com. RECORD THIS INFORMATION TECHNICAL SPECIFICATIONS Model Number: ����������������������������� Voltage: 25.2V Date Code: ��������������������������������� Power: 309W Date of Purchase: ��������������������������� (Keep receipt) Store of Purchase: ��������������������������� TIP: You can find the model and serial numbers on the QR code label on the bottom of the back of the handheld vacuum and battery.
PLEASE READ CAREFULLY AND KEEP FOR FUTURE REFERENCE. This Owner’s Guide is designed to help you get a complete understanding of your new Shark® vacuum. SharkNinja Operating LLC US: Needham, MA 02494 CAN: Ville St-Laurent, QC H4S 1A7 1-800-798-7398 sharkclean.com Illustrations may differ from actual product. We are constantly striving to improve our products; therefore the specifications contained herein are subject to change without notice. For SharkNinja U.S. Patent information, visit sharkninja.