Use and Care Manual

sharkclean.comsharkclean.com
EMPTYING THE DUST CUP
To remove Dust Cup, pull up on the release
button located on the side of dust cup handle.
Tilt dust cup forward, then lift to remove.
To reinstall, place the bottom of dust cup onto
the pod and then tilt until it clicks into place.
Hold the dust cup over the waste bin and
press the release button to open bottom of
dust cup.
To remove collected debris from Lint
Screen, lift the tab at the top of the dust
cup to open the lid. Remove debris from lint
screen toclean.
RINSE HEPA FILTER
EVERY YEAR
To remove the HEPA Filter, first pull the tab
on the bottom of the filter door, then lift o
the door. Press the tab on the left side of the
HEPA filter and pull out the filter.
To reinstall the HEPA filter, insert the right
side of filter first. Push tab on the left side of
the HEPA filter in until it clicks into place.
To reinstall the door, align the top first, then
press in the bottom until it clicks into place.
RINSE PRE-MOTOR FILTERS
EVERY MONTH
Remove Dust Cup, then lift out Filters.
Regularly rinse the filters to maintain your vacuum's suction power.
Rinse filters with cold water only. Allow all filters to air-dry for at least 24 hours before
reinstalling them to prevent liquid from being drawn into electronic parts.
CLEANING THE FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
IMPORTANT: Unplug the power cord before performing any maintenance.
Empty the dust cup each time you vacuum and periodically during cleaning,
when debris in the dust cup reaches the MAX fill line.
Post-Motor
HEPA Filter
Foam
Felt
Filter
Door
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
Replacement
Pre-Motor Foam &
Felt Filter Kit
XFFK320
Replacement
HEPA Filter
XHF320
Follow the previous instructions for removing filters. The Pre-Motor Filter should be replaced
every month. The HEPA Filter should be replaced every year.
REPLACING FILTERS