Use and Care Manual

sharkclean.comsharkclean.com
CHECKING FOR BLOCKAGES
Detach wand from pod and handle,
and check both ends for blockages.
Detach dust cup from vacuum pod.
Empty dust cup and remove debris from
lint screen in the top of the dust cup.
Detach handle from wand and hose to
check the openings on both ends.
Detach hose from handle by pressing
on the release button at the top
of the hose. Detach the hose from
the pod, and check openings
for blockages.
Detach wand and pod from floor
nozzle, tilt nozzle neck back, and
check opening for blockages.
DUST CUP BLOCKAGES
WAND BLOCKAGES
HANDLE BLOCKAGES
HOSE BLOCKAGES
NOZZLE BLOCKAGES
Clean o any debris on the bristles.
To access the nozzle hose, pinch the release touchpoints on the bottom of the nozzle, then lift
the cover and clear any blockages.
CLEANING THE BRUSHROLL
MAINTENANCE
Self-Cleaning Brushroll
The self-cleaning brushroll actively removes hair wrap as you vacuum. If any hair is wrapped
around the brushroll, continue vacuuming. This will allow the self-cleaning brushroll to remove
the hair wrap and send it to the dust cup. If some hair wrap remains after continued use, remove
the cover from the bottom of the nozzle and carefully clean o the brushroll.
To minimize the risk of power cord damage,
DO NOT run the vacuum over the power
cord.If this occurs, immediately shut o
power to the vacuum and remove the cord
from the brushroll or nozzle.
1. 1. DO NOT pull or carry vacuum cleaner
by the cord or use cord as a handle.
2. 2. DO NOT unplug by pulling on the cord.
Grasp the plug, not the cord.
3. 3. DO NOT close the door on the cord.
4. 4. DO NOT pull the cord around sharp
corners.
5. 5. DO NOT leave the cord near heated
surfaces.
CORD MAINTENANCE
DEBRIS WRAPPED
AROUND BRUSHROLL