SE200 series OWNER’S GUIDE WWW.SHARKCLEAN.
IMPORTANT SAFETY INSTRUCTIONS For Household Use Only WHEN USING YOUR SHARK® STEAM MOP, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING: WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY READ ALL INSTRUCTIONS BEFORE USING YOUR STEAM MOP. DANGER OF SCALDING. Please use caution when using the steam mop. The steam emitted from the openings is very hot.
11. D O NOT unplug by pulling on power cord. To unplug, grasp the plug not the power cord. Do not use extension cords or outlets with inadequate current carrying capacity. 12. D O NOT put any objects into openings. Do not use with any opening blocked. 13. D O NOT put hands or feet under the steam mop. Unit gets very hot. 14. U se ONLY on flat, stable horizontal surfaces. Do not use on walls, counters, windows, chairs or tables. 15.
Quick Start a fig. 2 b fig. 1 fig. 3 ASSEMBLE FILL 1 Fit together the backsaver handle (a) and lower pole (b). Insert the assembled pole into the top of the mop as shown. (fig. 1) 3 2 Place the micro-fiber cleaning pad underneath the mop head, with quick fastener strips facing up. Simply press the mop to the pad to attach it. (fig. 2) TOLL FREE: 1-800-798-7398 Before plugging in the mop, remove the cap to fill the water tank.
Quick Start fig. 5 fig. 4 STEAM CLEANING BACKSAVER 4 Plug in the steam mop and the STEAM light will blink blue in the standby mode. Press the STEAM button to activate the steam. The LED indicator light will turn solid blue. (fig. 4) 5 Use the Shark® Steam Mop with backsaver handle to access tight areas. Press the release button on the handle to bend and lock the steam mop in the backsaver position. Press the release button on the handle and pull up to straighten the handle. (fig. 5) www.sharkclean.
This manual covers models: SE200 11 SE200Z 11 TECHNICAL SPECIFICATIONS Voltage: 120V., 60Hz. Power: 1550 Watts Water Capacity: 310 ml (10.5 fl. oz.
Contents Thank you for purchasing the Shark® Steam Mop. Getting started........................................................................... 2 Using your steam mop............................................................4 Care and storage of your steam mop............................... 7 Troubleshooting.........................................................................9 Warranty and registration.....................................................12 www.sharkclean.
Getting Started When assembling your steam mop there may be a little water in or around the water tank. This is because we test all our steam mops 100% before you buy them, so you get a quality Shark® Steam Mop. fig. 3 A D C B G E fig. 1 F fig. 2 A Backsaver handle ASSEMBLY B Lower Pole 1 emove all the parts from the R package. Verify all the listed parts are included. 2 I nsert the lower pole into the Backsaver handle as shown. (fig.
Your micro-fiber cleaning pads should be replaced every 2-3 months to maximize cleaning performance. Calcium and mineral deposits can build up and impact the performance of your steam mop over time. To extend the life of your product we recommend that you use distilled water or Shark®’s Water Filtration Bottle. Visit www.sharkclean.com to order. fig. 4 fig. 5 fig. 6 fig. 3 ATTACHING THE MICRO-FIBER PAD 1 lace the micro-fiber cleaning pad P on the floor with the quick fastener strips facing up.
Using Your Steam Mop When you use your steam mop for the first time or if you have not used the unit in awhile, it may take a minute or two for the water to travel through the pump and into the heater to create steam. If you have waited a few minutes and you still do not see any steam, reference the troubleshooting section on page 11. fig. 1 fig. 3 fig. 2 I MPORTANT: Your steam mop needs water to make steam! Never use your steam mop without water in the tank.
If your Steam Mop stops steaming, it could be out of water. Press the STEAM button so that the LED light blinks BLUE, unplug the power cord from the electrical outlet and refill the water tank at anytime. fig. 4 fig. 5 OTE: It may take a few seconds for N the mop to warm up and and start steaming after you plug it in. If you press the STEAM button and the unit does not begin to steam immediately, just wait a few seconds for the mop to heat up to a deep cleaning and sanitizing temperature.
Using Your Steam Mop - cont’d fig. 7 fig. 6 BACKSAVER FEATURE 1 lean under furniture and tight areas C using the Shark® Backsaver™ locking handle. Press the handle release button and apply slight pressure to bend the handle. The Shark® Backsaver™ joint will lock at a perfect, access maximizing angle. (fig. 6) 2 ress the release button on the P handle again and pull up to straighten. (fig.
Care of Your Steam Mop fig. 1 fig. 3 fig. 2 AFTER USE AND STORAGE 1 hen you have finished using the W Steam Mop, press the STEAM button to stop the unit from steaming. The LED light will blink BLUE. Unplug the cord from the outlet and place the mop into the upright position. (fig. 1) Let the unit cool for 2-3 minutes. 2 arefully pull the micro-fiber cleaning C pad from steam mop. (fig. 2) Wash the pad if necessary (for washing instructions see page 8). 3 mpty the water tank before storage.
Care of Your Steam Mop - cont’d. fig. 4 fig. 5 CARE OF YOUR MICRO-FIBER CLEANING PAD 1 ash pads in warm water. Wash W separately from other laundry. Only use liquid detergent (not powder detergent). Do not use fabric softeners. Line dry or dry on a low dryer setting. (fig. 4) 2 I f there are loose threads on the pad carefully cut the threads with scissors. Do not pull on them or cut at the base. (fig. 5) I MPORTANT: The micro-fiber cleaning pad may be very hot from the steam.
Trouble Shooting PROBLEM The Steam Mop will not turn-on. POSSIBLE REASONS & SOLUTIONS Your steam mop should be securely plugged into a 120V AC electrical outlet only. Is the LED light on? If not, check your fuse or breaker. If your unit still does not work, call 1-800-798-7398. The Steam Mop will not make steam. Cannot select steam setting/flashing blue light remains on. The Steam Mop leaves water on the floor. The Steam Mop left a white spot on the floor.
Notes 10 TOLL FREE: 1-800-798-7398
Notes www.sharkclean.
ONE (1) YEAR LIMITED WARRANTY EURO-PRO Operating LLC warrants this product to be free from defects in material and workmanship for a period of one (1) year from the date of the original purchase, when utilized for normal household use, subject to the following conditions, exclusions and exceptions. If your appliance fails to operate properly while in use under normal household conditions within the warranty period, return the complete appliance and accessories, freight prepaid.
Notes www.sharkclean.
U.S.: EURO-PRO Operating LLC Newton, MA 02459 Canada: EURO-PRO Operating LLC 4400 Bois Franc Ville St. Laurent, Québec H4S 1A7 1-800-798-7398 www.sharkclean.com COPYRIGHT© EURO-PRO OPERATING LLC 2011 PRINTED IN CHINA SE200.E.110415 Illustrations may differ from actual product. US Patent No.