WWW.SHARKCLEAN.
IMPORTANT SAFETY INSTRUCTIONS For Household Use Only WHEN USING AN ELECTRICAL APPLIANCE, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE OBSERVED, INCLUDING THE FOLLOWING: READ ALL INSTRUCTIONS BEFORE USING YOUR SHARK NAVIGATOR® LIFT-AWAY® PRO. POLARIZED PLUG: To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug.
HOSE ATTACHMENTS: 1. DO NOT use if air flow is restricted; if the air paths, the hose, or the accessories become blocked, turn the vacuum cleaner off. Remove all obstructions before you turn on the unit again. 2. Keep the end of the hose and accessory openings away from face and body. 3. Keep cleaning tools and hose suction openings away from hair, face, fingers, uncovered feet, or loose clothing. 4. Only use manufacturer’s recommended attachments. GENERAL USE: 1. Use only as described in this manual.
THIS MANUAL COVERS MODEL NUMBERS: NV355 NV356E NV358 TECHNICAL SPECIFICATIONS Voltage: 120V.
Contents Thank you for purchasing the Shark Navigator® Lift-Away® Pro Getting Started 6 Mode 1: Upright Vac 8 Mode 2: Portable Lift-Away 10 Above-Floor Cleaning 11 Storage 12 Maintenance 13 ® Emptying the Dust Cup 13 Cleaning the Pre-Motor Filters 13 Cleaning the Post-Motor HEPA Filter 14 Cleaning the Power Brush 14 Cleaning the Motorized Floor Brush 15 Checking for Blockages 15 Ordering Parts 17 Troubleshooting Guide 18 Warranty 19 www.sharkclean.
Getting Started g a h Fig. 1 b Fig. 2 i c j Fig. 3 Fig. 4 Fig. 5 Fig. 6 d ACCESSORIES: HARD FLOOR HERO™ Provides outstanding hard floor cleaning for not just surface litter, but also stuck-on dust and debris. It is small enough to get into hard-to-reach areas and can conveniently be stored on board. (Fig. 1) e CREVICE TOOL Reach deep into narrow spaces and clean between cushions, under radiators and baseboards and in hard to reach crevices and corners. (Fig.
Your new Shark Navigator® Lift-Away® Pro vacuum cleaner can easily be configured into different cleaning modes to meet all your cleaning needs: upright vacuum and portable Lift-Away® - both with constant suction power. Fig. 7 Fig. 8 MODES: 1 UPRIGHT VAC 2 PORTABLE LIFT-AWAY® Upright vacuuming - floors and carpets. (Fig. 7) Take the Lift-Away® with you around the house to clean hard to reach places. (Fig. 8) www.sharkclean.
Mode 1: Upright Vac WARNING: The On/Off switch is on the top of the Lift-Away® canister. Always ensure the power is OFF (“O” position) before plugging and unplugging. To reduce the risk of electric shock, unplug the unit before assembling, adding or removing attachments or converting modes. b d a e Upper Cord Storage Wrap c Fig. 9 Fig. 10 Fig. 11 TO ASSEMBLE: 1 Place the floor nozzle on a level surface.
Suction Release Collar c a Release suction for easier push & pull on high pile carpets and area rugs. b Fig. 12 Fig. 13 TO USE: 1 R otate the cord release to quickly release the power cord. 2 Secure the power cord in the cord hook. 4 NOTE: The rotating brush on the motorized floor brush will not spin unless the nozzle is flat against the floor and the handle is tilted back.
Mode 2: Portable Lift-Away® You can carry your vacuum cleaner in both modes by the carry handle located on top of the dust cup. a a b Fig. 14 Fig. 16 Fig. 15 PORTABLE LIFT-AWAY® 1 S eparate the portable Lift-Away® canister from the floor nozzle by pressing the red release button (a) on the side of the canister. Gently hold the nozzle to the floor with your foot and pull the canister up. (Fig.
Above-Floor Cleaning Release suction when dusting delicate objects, furniture or draperies. a Fig. 17 Suction Release Collar CLEAN ABOVE THE FLOOR IN UPRIGHT VAC OR PORTABLE LIFT-AWAY® MODE 1 P ress the handle release button and pull the handle up or press the extension wand release button and pull the extension wand up. 2 A ttach desired accessory onto the end of either the extension wand or the handle. (Fig. 17) 3 our vacuum has tremendous suction power.
Storage Quick Cord Release Lower Cord Storage Clip Fig. 18 STORE YOUR VACUUM SAFELY 1 Convert your vacuum back to upright vac mode. 2 R otate the upper quick cord release to its upright position and coil the power cord loosely around the two clips. Clip the plug onto the cord to secure. (Fig. 18) 3 S tore the dusting brush and the crevice tool on the mounts on the accessory holder.
Maintenance COMPONENT MAINTENANCE SCHEDULE 1 Dust Cup Empty each time you vacuum. 2 Pre-Motor Foam Filter Rinse and air dry every 3 months under normal use. 3 Pre-Motor Felt Filter Rinse and air dry every 3 months under normal use. 4 Post-Motor HEPA Filter Clean once every 2 years or as needed. IMPORTANT: Loss of Suction may occur if foam filters are not cleaned every 3 months. Rinse and allow to air dry completely. Also, tap loose dirt off filter between washes as needed.
Maintenance - cont. a Fig. 23 Fig. 26 Fig. 24 Fig. 25 Fig. 27 CLEANING THE POST-MOTOR HEPA FILTER CLEANING THE POWER BRUSH 1 R emove the filter cover from the front of the vacuum by pulling up on the tab and pulling the cover away from the vacuum. (Fig. 23) 1 S lide the locking latch (a) forward and tilt the bottom cover upward to remove. (Fig. 26) 2 2 Take out the HEPA filter by pulling it straight out.
Rotating Brush Fig. 28 CLEANING THE MOTORIZED FLOOR BRUSH CHECKING FOR BLOCKAGES When your motorized floor brush needs cleaning or locks onto an object, it automatically shuts down to prevent damage to your lifetime belt. The indicator light will illuminate red warning you to turn off the vacuum and clear blockage immediately. The light will reset itself once blockage has been cleared and power has been cycled on/off or vacuum has been locked in the upright position.
Maintenance - cont’d Fig. 31 Fig. 29 Fig. 32 Fig. 30 Fig. 33 4 Hose and Connections to Vacuum • Detach the stretch hose from the back of the portable Lift-Away® canister by squeezing the tabs together and pulling up. (Fig. 29) Straighten out the hose and look inside for blockages. • Remove the dust cup and extension wand and separate the portable Lift-Away® canister from the motorized floor brush. Look in all 4 openings for any blockages. (Fig.
Ordering Parts 1 2 3 4 5 PART PART NO. 1 Pre-Motor Filter Set XFF350 2 HEPA Filter XHF350 3 Dusting Brush & Crevice Tool 112FFJ 4 Turbo Brush 137FFJ 5 Wide Upholstery Tool 261FFJ46 To order additional parts or accessories go to www.sharkclean.com or call 1-800-798-7398. www.sharkclean.
Troubleshooting Guide PROBLEM POSSIBLE REASONS & SOLUTIONS Vacuum is not picking up dirt. Check filters to see if they need cleaning. Follow instructions for rinsing and drying the filters before re-inserting back into the vacuum. (See “Maintenance” sections for instructions.) Dust cup may be full; empty dust cup. Check hose and hose connections for blockages; clear blockages if required. If dust cup is empty, and attachment inlets are clear, check for other blockages.
FIVE-YEAR (5) LIMITED WARRANTY SharkNinja Operating LLC warrants this product to be free from material defects and workmanship for a period of five (5) years from the date of purchase when utilized for normal household use, subject to the following conditions, exclusions and exceptions. The liability of SharkNinja Operating LLC is limited solely to the cost of the repair or replacement of the unit at our option.
SharkNinja Operating LLC U.S.: Newton, MA 02459 Canada: Ville St. Laurent, Québec H4S 1A7 1-800-798-7398 www.sharkclean.com Copyright © SharkNinja Operating LLC 2016 For SharkNinja U.S. Patent information visit http://www.sharkninja.com/USPatents. Lift-Away, Shark and Shark Navigator are registered trademarks of SharkNinja Operating LLC. Printed in China Illustrations may differ from actual product.