User Guide
sharkclean.comsharkclean.com
MAINTENANCE
SELF-CLEANING BRUSHROLL
MAINTENANCE
To access the brushroll, push up on the tabs on the
brushroll access door, then lift o the door.
Lift out the brushroll. Clean o any debris. Reinstall
the brushroll, inserting the flat end first. Close the
brushroll access door and press down until both
sides click into place.
NOTE: When cutting away debris, be sure not to cut the brushroll.
NOTE: Replace brushroll every 6 to 12 months, or when visibly worn. See sharkaccessories.com for replacement parts.
NOTE: The pre-motor foam and felt filters should be
replaced every 2.5 years. The post-motor filter should
be replaced every 3 years.
NOTE: Clean the mesh filter inside the dust bin with a
small brush once a month.
CLEAN POST-MOTOR FILTER EVERY YEAR
Press the button at the top of the Filter Door, then
tilt the door and lift it o. Remove the Post-Motor
Filter from the base. To reinstall the post-motor filter,
insert it into the base and replace the filter door.
CLEAN PRE-MOTOR FILTERS ONCE A MONTH
Remove the base dust bin, then lift out both Pre-
Motor Filters.
Regularly clean and replace your filters to keep your vacuum's suction power optimal.
To clean filters, rinse with cold water ON LY to prevent damage from cleaning chemicals. Allow all filters to
air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electricparts.
The Self-Cleaning Brushroll removes debris over time as it cleans. If some debris remains wrapped around
the brushroll, continue cleaning to allow the brushroll to remove it.
If some debris remains on the brushroll after continued cleaning, follow the steps below to remove it.
CLEANING AND REPLACING THE BASE FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
Filter
Door