ION ROBOT® Robot Vacuum for United States only RV700 SERIES 3 OWNER'S GUIDE
IMPORTANT SAFETY INSTRUCTIONS PLEASE READ CAREFULLY BEFORE USE • FOR HOUSEHOLD USE ONLY If the charging cable plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT force into outlet or try to modify to fit. WARNING To reduce the risk of fire, electric shock, injury, or property damage: GENERAL WARNINGS When using an electrical appliance, basic precautions should always be followed, including the following: 1.
ABOUT THE SHARK ION ROBOT® ABOUT THE SHARK ION ROBOT® With Auto-Sense® Navigation, your robot uses an array of sensors to navigate around walls, furniture legs, and other obstacles while it cleans. The robot may gently bump into obstructions or linger in one spot, and it may not cover every area in a single cleaning. For best results, prepare your home as indicated below, and schedule a daily cleaning to ensure all floor areas are regularly maintained.
PREPARING FOR USE CHARGING THE SHARK ION ROBOT® INSTALLING THE SIDE BRUSHES CHARGING Snap the 2 color-coded side brushes onto the matching colored pegs on the bottom of the robot. CHARGING DOCK SET-UP IMPORTANT: The Shark ION Robot has a pre-installed rechargeable battery. Battery must be fully charged before using. To charge, the Power button on the side of the robot must be in the ON position (I).
CHARGING THE SHARK ION ROBOT® USING THE SHARK ION ROBOT® CHARGE INDICATOR LIGHTS BUTTONS AND INDICATOR LIGHTS CLEAN BUTTON Press to begin a cleaning session. Press again to stop. In Use Full Charge Nearly Full Mid Charge Low Charge While Charging No Charge or Off The blue charge indicator lights show how much charge is remaining. DOCK BUTTON Press to stop cleaning and send robot back to the charging dock. While the robot is charging, all three blue LED lights will cycle.
USING THE SHARK ION ROBOT ® MAINTENANCE USING THE SHARKCLEAN® APP AND VOICE CONTROLS The SharkClean app will guide you through easy setup of your robot. CAUTION: Turn off power before performing any maintenance. Control the unit remotely: • Schedule cleaning times for up to 7 days a week. • Start, stop, or dock your robot from your phone anywhere with Wi-Fi connectivity.
MAINTENANCE MAINTENANCE CLEANING THE FILTER CLEANING THE MULTI-SURFACE BRUSHROLL CLEAN FILTER EVERY WEEK. REPLACE FILTERS REGULARLY OR AS NEEDED. See sharkaccessories.com for replacement filters. THE BRUSHROLL NEEDS OCCASIONAL MAINTENANCE. REPLACE BRUSHROLL EVERY 6 to 12 MONTHS, OR WHEN VISIBLY WORN. See sharkaccessories.com for replacement parts. Remove and empty the dust bin. Clean any hair or debris off the Anti-Tangle Comb on the back of the dust bin. Pull filter out of the dust bin by the tabs.
MAINTENANCE MAINTENANCE CLEANING SENSORS AND CHARGING PADS CLEANING THE WHEELS CLEAN SENSORS AND CHARGING PADS PERIODICALLY AS NEEDED. With a dry cloth or cleaning brush, gently dust off the sensors and pads located on the bottom of the robot. IMPORTANT: The robot uses cliff sensors to avoid stairs and other steep drops. Sensors may work less effectively when they are dirty. For best results, clean sensors regularly. CLEANING SIDE BRUSHES REMOVE AND CLEAN FRONT WHEEL EVERY WEEK.
MAINTENANCE MAINTENANCE REPLACING THE BATTERY TROUBLESHOOTING If any error lights are illuminated or flashing on your Shark Ion Robot®, see the error code chart below: ERROR CODE SOLUTION ALL LED LIGHTS are off Power may be turned off or battery may need charging. Turn power switch to On position. If no response, place robot on dock to charge. CLEAN (RED) + ! flashing together Suction motor failure. Remove blockages and clean filters. Remove dust bin and make sure nothing is blocking suction.
END-USER LICENSE AGREEMENT FOR SHARKNINJA SOFTWARE END-USER LICENSE AGREEMENT FOR SHARKNINJA SOFTWARE IMPORTANT: PLEASE READ THE TERMS AND CONDITIONS OF THIS LICENSE AGREEMENT CAREFULLY BEFORE CONTINUING WITH THIS PROGRAM INSTALL OR USE OF THIS PRODUCT: SharkNinja Operating LLC’s (“SharkNinja”) End-User License Agreement (“EULA”) is a legal agreement between You (either a single entity or an individual) and SharkNinja for SharkNinja’s Software Applications, including those installed by You onto your Shark
REGISTER YOUR PURCHASE registeryourshark.com ONE (1) YEAR LIMITED WARRANTY The One (1) Year Limited Warranty applies to purchases made from authorized retailers of SharkNinja Operating LLC. Warranty coverage applies to the original owner and to the original product only and is not transferable.
NOTES NOTES ������������������������������������������������������������������������������� ������������������������������������������������������������������������������� ������������������������������������������������������������������������������� ������������������������������������������������������������������������������� ������������������������������������������������������������������������������� ������������������������������������������������������������������������������� �����
FCC WARNINGS This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to parts 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and accordance with the instructions, may cause harmful interference to radio communications.
