BotBoundary™ Setup Guide

PREPPING YOUR HOME USING

BOTBOUNDARY

™

STRIPS

Use the BotBoundary strips to quickly and easily create

“no-go zones” to keep your robot out of the areas you

would like it to avoid. These may include:

• Near power cords that might cause tangles

• Hallways where you’d rather your robot not travel

• Around furniture with low clearance that may trap

your robot

BotBoundary strips

SEE OTHER SIDE FOR

USAGE INSTRUCTIONS

ION

ROBOT

PAGE 1
ION ROBOT TM PREPPING YOUR HOME USING BOTBOUNDARY ™ STRIPS Use the BotBoundary strips to quickly and easily create “no-go zones” to keep your robot out of the areas you would like it to avoid.
PAGE 2
USAGE INSTRUCTIONS 1. Cut the BotBoundary™ strip to the desired length (18-inch minimum). The strip must be long enough to cover the entire perimeter of an object or span the length of the doorway you’d rather your robot not cross. (18” Minimum) 2. Simply place the BotBoundary strip flat on the floor or under an area rug. For best results, make sure your BotBoundary strip is completely flat against the floor. 3. You can create angles to customize the BotBoundary strips to fit your home.