WWW.SHARKCLEAN.COM LIGHT & EASY™ STEAM MOP S3250 11 OWNER’S GUIDE S3250_instructions_100526.
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS For Household Use Only 1. Use the system only for its WHEN USING YOUR SHARK® intended use. STEAM MOP, BASIC SAFETY 2. DO NOT use outdoors. PRECAUTIONS SHOULD ALWAYS 3. DO NOT leave the appliance BE FOLLOWED, INCLUDING THE unattended when plugged in. Always unplug the power cord FOLLOWING: WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY READ ALL INSTRUCTIONS BEFORE USING YOUR LIGHT & EASY™.
Quick Start Quick Start fig. 5 fig. 3 fig. 4 fig. 1 1 2 ASSEMBLE Fit together the extension tubes as shown in the illustration. (fig. 1) Place the micro-fiber cleaning pad underneath the mop head, with quick fastener strips facing up. Simply press the mop to the pad to attach it. (fig. 2) TOLL FREE: 1-800-798-7398 S3250_instructions_100526.indd 4-5 fig. 2 3 FILL Remove the cap to fill the water tank. Use the filling flask and funnel to fill the tank with water to the “MAX” fill line.
Contents Thank you for purchasing the Shark® Light & Easy™ Steam Mop. GETTING STARTED.................................................................. 2 USING YOUR STEAM MOP....................................................6 USING YOUR ACCESSORIES................................................9 STORAGE AND CARE OF YOUR STEAM MOP........... 10 TROUBLESHOOTING.............................................................12 WARRANTY AND REGISTRATION....................................
English Getting Started When assembling your steam mop there may be a little water in or around the water tank. This is because we test all our steam mops 100% before you buy them, so you get a quality Shark® Light & Easy™ Steam Mop. c b a d e f fig. 1 g fig. 2 h a Upper Handle Tube with Backsaver benefit b Lower Handle Tube c Steam Mop Base d 1 All-Purpose Cleaning Pad and 1 Heavy Duty Cleaning Pad e Filling Flask f Funnel g Fresh Breeze Scent ASSEMBLY 1 Remove all the parts from the package.
English Getting Started Your micro-fiber cleaning pads should be replaced every 3 months to maximize cleaning performance. fig. 2 fig. 2 fig. 3 fig. 1 ATTACHING THE MICRO-FIBER PAD 1 Place the micro-fiber cleaning pad on the floor with the quick fastener strips facing up. Place the Light & Easy™ Steam Mop on the top of the pad to attach. (fig. 1) IMPORTANT: Only add water to the tank. Chemicals or cleaning solutions may be unsafe or cause damage. Replacement micro-fiber pads are available at www.
English Using Your Light & Easy™ Steam Mop 1 fig. 1 When you use your steam mop for the first time or if you have not used the unit in awhile, it may take a minute or two for the water to travel through the pump and into the heater to create steam. Get it started by pumping the handle a few times. If you have waited a few minutes and you still do not see any steam, reference the troubleshooting section on page 12. If your Light & Easy™ Steam Mop stops steaming, it could be out of water.
Using Your Light & Easy™ Steam Mop English Using Your Accessories The Light & Easy™ Steam Mop will not pick-up solid particles or hair from carpets or areas rugs, but it is great for deodorizing and freshening carpet surfaces against tough odors. fig. 1 fig. 2 1 Clean under furniture and tight areas using the Shark® Backsaver™ locking handle. Press the handle release button and apply slight pressure to bend the handle. The Shark® Backsaver™ joint will lock at a perfect, access-maximizing angle. (fig.
English Care of Your Light & Easy™ Steam Mop Care of Your Light & Easy™ Steam Mop fig. 5 fig. 1 fig.2 AFTER USE AND STORAGE 1 When you have finished using the Light & Easy™ Steam Mop, unplug the cord from the outlet and place the mop into the upright position (fig. 1) and let the unit cool 2-3 minutes. Release steam by pumping the handle several times. 2 Carefully separate micro-fiber cleaning pad from steam mop, avoiding contact with the hot pocket or dirt. (fig.
English Trouble Shooting PROBLEM ONE (1) YEAR LIMITED WARRANTY POSSIBLE REASONS & SOLUTIONS The Light & Easy™ Steam Mop will not turn-on. Your steam-mop should be securely plugged into a 120V AC electrical outlet only. Check your fuse or breaker. If your unit still does not work, call 1-800-798-7398. Light & Easy™ Steam Mop will not make steam. Is there water in the water tank? If not, add water to your Steam Mop following instructions on page 5. Light & Easy™ Steam Mop leaves water on the floor.
U.S.: EURO-PRO Operating LLC Newton, MA 02459 Canada: EURO-PRO Operating LLC 4400 Bois Franc Ville St. Laurent, Québec H4S 1A7 1-800-798-7398 www.sharkclean.com COPYRIGHT© EURO-PRO OPERATING LLC 2010 PRINTED IN CHINA REV. 100526 Illustrations may differ from actual product. S3250_instructions_100526.
