OWNER’S GUIDE S3501UKL S3501UKL_IB_ENG_101006.
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS For Household Use Only WHEN USING YOUR SHARK STEAM MOP, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING: READ ALL INSTRUCTIONS BEFORE USING YOUR STEAM MOP. DANGER OF SCALDING. Please use caution when using the steam mop. The steam emitted from the steam mop is very hot.
11. DO NOT unplug by pulling on power cord. To unplug, grasp the plug not the power cord. Do not use extension cords or outlets with inadequate current carrying capacity. 12. DO NOT put any objects into openings. Do not use with any opening blocked. 13. DO NOT put hands or feet under the steam mop. Unit gets very hot. 14. Use ONLY on flat, horizontal surfaces. Do not use on walls, counters or windows. 15.
Quick Start When assembling your steam mop there may be a little water in or around the water tank. This is because we test all our steam mops 100% before you buy them, so you get a quality Shark® Steam Mop. 1 2 3 1 ASSEMBLE Insert the mop handle into the pump actuator (the tube that leads to the tank). Push the mop handle and pump actuator together in until you hear it click into place. 2 Select a mop head and cleaning pad.
QUICK TIP: For easier pushing and pulling, extend the handle length DIRT CAN’T HIDE ON EITHER SIDE! All new design allows for optimal cleaning! When one side of the pocket gets dirty, just turn the mop head over and clean with the other side of the pocket. Quick Start 5 6 5 6 PREPARE For your comfort, you can adjust the height of the mop. Just lift the latch on the tube 90 degrees to the open position.
This appliance complies with the WEEE-Directive 2002/96/EC on the disposal of electrical and electronic equipment (WEEE). This appliance complies with the European directives for electromagnetic compatibility (EMC) 2004/108/EC and its revisions, as well as Low Voltage Directive (LVD) 2006/95/EC and its revisions. This marking indicates that this product should not be disposed with other household wastes throughout the EU.
Contents Thank you for purchasing the Shark® Steam Pocket Mop. Getting Started................................................................................. 2 Using Your Steam Mop.................................................................. 5 Using Your Carpet Glider.............................................................. 7 Care of Your Steam Mop............................................................... 8 Ordering Replacement Parts ...................................................
Getting Started When assembling your steam mop there may be a little water in or around the water tank. This is because we test all our steam mops 100% before you buy them, so you get a quality Shark® Steam Pocket Mop.
1 2 3 1 2 ASSEMBLE Insert the mop handle into the pump actuator (the tube that leads to the tank). Push the mop handle and pump actuator together in until you hear it click into place. 3 Snap the mop head into the base to secure it. Press the release button to exchange mop heads. Select a mop head and cleaning pad. Fit one side of the pocket onto the head first, then using the lavender loop, pull the pocket over the head. Attach the quick fasteners on the top of the pocket to secure in place. www.
Getting Started - cont’d IMPORTANT: First things first, always make sure the mop is UNPLUGGED from the wall when not in use. Never fill the mop, attach the mop head, change or remove the microfibre pocket when the mop is plugged into the wall. If you have hard water you might want to use distilled water to prolong the life of the Shark® Steam Mop. Make sure you only add water to the tank. Chemicals or cleaning solution may damage the appliance and could be unsafe for you and your family.
Using Your Steam Mop IMPORTANT: Make sure you don’t use the mop without attaching a microfibre pocket and adding water to the tank first. When you are using the mop for the first time, it might take longer than the normal 30 seconds to start steaming. Just pump the handle a few times in a downward motion to prime the pump and it should be ready. 2 1 NOTE: Make sure the floors are swept or vacuumed before using the steam mop.
Using Your Steam Mop - cont’d 4 3 3 For your comfort, you can adjust the height of the mop. Just lift the latch on the tube 90 degrees to the open position. Holding the handle, extend the tube to the height that’s right for you and then close latch to locked position. 4 When one side of the microfibre pocket gets dirty, just flip the mop head and you can quickly start using the other side. Dirt can’t hide on either side.
Using Your Carpet Glider The Steam Mop won’t clean your carpeting or area rugs. However, it’s great for deodorising and freshening. 1 THE CARPET GLIDER 1 The Carpet Glider can be used with the rectangle mop head to lightly steam your carpet and area rugs. Just place the mop head on top of the glider and move back and forth across a section of the carpet. The steam mop won’t clean your carpeting or areas rugs, but it’s great for deodorising and freshening.
Care of Your Steam Mop AFTER USE AND STORAGE 1 When you have finished using the steam mop, and your floors are clean, unplug the cord from the outlet and move it into an upright position. Let the unit cool 2-3 minutes and release steam by pumping the handle several times before removing the microfibre cleaning pocket from the mop head.
2 1 40° KEEPING YOUR MICROFIBRE CLEANING POCKET AS GOOD AS NEW 1 We recommend washing your microfibre pockets separately from other fabrics to avoid picking up lint. 2 If there are loose threads on the pocket carefully cut the thread with scissors. Don’t pull on them or cut at the base. Only use liquid detergent. (no powder detergent) Don’t use any fabric softeners or bleach. Line dry. Do not tumble dry. www.lakeland.co.uk S3501UKL_IB_ENG_101006.
Ordering Replacement Parts 1 2 3 ORDERING REPLACEMENT PARTS To order additional parts and accessories, feel free to contact us at: Shark Customer Services PO Box 298 Mirfield WF14 9BA PART 1 1 Standard and 1 Triangle Cleaning Pads 2 2 XL Cleaning Pads 3 2 Steam Duster Cleaning Pads PART NO. XT3501UKL XLT3501UKL XT3501SDUKL Freephone 0800 862 0453 10 www.lakeland.co.uk S3501UKL_IB_ENG_101006.
Troubleshooting Guide PROBLEM The Steam Mop will not turn on. Steam Mop will not make steam. Steam Mop leaves water on the floor. POSSIBLE REASONS & SOLUTIONS Your Steam Mop should be securely plugged into a 220-240V AC electrical outlet only. Check your fuse or breaker. If your unit still doesn’t work, give us a call at Freephone 0800 862 0453. Prime the pump, see page 5 for more information. Is there water in the water tank? If not, add water to your Steam Mop following the instructions.
Notes 12 www.lakeland.co.uk S3501UKL_IB_ENG_101006.
Notes www.lakeland.co.uk S3501UKL_IB_ENG_101006.
Shark Customer Services PO Box 298 Mirfield WF14 9BA Freephone 0800 862 0453 www.lakeland.co.uk Technical Details Model number: Input: Main unit voltage: S3501UKL 11 1550 Watts 220-240V., 50 Hz. COPYRIGHT© EURO-PRO OPERATING LLC 2010 PRINTED IN CHINA S3501UKL.E.101006 Illustrations may differ from actual product. Not to be disposed of with other household waste. IPX4 S3501UKL_IB_ENG_101006.
