Use and Care Manual

6sharkclean.com
Assembling Your Steam Pocket
®
Mop
WARNING: Always make sure the Steam Mop
is UNPLUGGED when not in use. Never fill the
Steam Mop or attach the mop head when
the Steam Mop is plugged into an electrical
outlet. Unplug from the electrical outlet and
allow to cool before you fill the Steam Mop,
or attach or remove the head. To prolong the
life of your Steam Mop, we recommend using
distilled water. Make sure you add only water
to the tank. Chemicals or cleaning solutions
(including vinegar) may damage the Steam Mop
and could be unsafe for you and your family.
STEAM MOP ASSEMBLY
1 Insert the Steam Mop handle into the Steam Mop
body. Push the handle in until you hear it click into
place. (fig. 1)
2 Slide the Genius
™
Mop Head into the Steam Mop body.
Push until you hear it click securely into place. (fig. 1)
To detach the Genius Mop Head, press the release
button and slide off.
3 To attach the Dirt Grip
™
pad, spread the pad on the
floor with the pocket side up. Center the Genius Mop
Head above the pad, then press the pad release
button on the back of the Steam Mop body (fig. 2a).
Both sides of the Genius Mop Head will drop open
(fig. 2b). Slip the Genius Mop Head’s four corner tabs
into the four corner pockets of the pad (fig. 3 and
fig. 4). Gently press one side of the Genius Mop Head
to the floor until that side clicks into place (fig. 5).
Repeat on the other side (fig. 6).
4 Pull down on the water tank lid to open (fig. 7).
5 Use the filling flask to pour water into the water tank
(fig. 8). Water can be poured into the tank directly. Do
not overfill past the water line on the fill flask. Press
the water tank lid firmly to close it.
fig. 1
fig. 7
fig. 8
fig. 3fig. 2b
fig. 2a
fig. 5 fig. 6
fig. 4