Operator`s manual

ManualsBrandsShark ManualsPortable GeneratorSSG-503027E

SSG SERIES PRESSURE WASHER OPERATOR’S MANUAL

Shark SSG • Rev. 7/02

Air Shutter

Locking Screw

Air Band

Locking Screw

Air Shutter

Locking Screw

Air

Shutter

Air Band

Air Adjustment:

Machines are preset and performance tested at the fac-

tory - elevation 100'. A one-time initial correction for your

location will pay off in economy, performance, and ex-

tended service life. If a smoky or eye-burning exhaust is

being emitted from the stack, two things should be

checked. First, check the fuel to be certain that kero-

sene or No. 1 home heating fuel is being used. Next,

check the air adjustment on the burner.

To adjust, start machine and turn burner ON. Loosen two

locking screws found in the air shutter openings (refer to

illustration) and close air shutter until black smoke appears

from burner exhaust vent. Note air band position. Next,

slowly open the air shutter until white smoke just starts to

appear. Turn air shutter halfway back to the black smoke

position previously noted. Tighten locking screws.

If the desired position cannot be obtained using only the

air shutter, lock the air shutter in as close a position as can

be obtained, then repeat the above procedure on the air

band setting.

Coil Removal:

Removal of coil because of freeze breakage, or to clean

soot from it can be done quickly and easily.

1. Disconnect hose from pump to inlet side of the coil.

2. Carefully disconnect the thermostat sensor making

sure you do not crimp the capillary tube.

3. Remove burner assembly from combustion chamber.

4. Remove the 3-3/8" bolts from each side of coil and

tank assembly (these bolts are used to fasten tank

to chassis).

5. Remove fittings connected to the 1/2" pipe nipples

from inlet and discharge sides of coil.

6. Remove top tank wrap, bend back insulation tabs

and fold back blanket.

7. Remove bolts that hold down coil to bottom wrap.

8. Remove coil.

9. Replace or repair any insulation found to be torn or

broken.

10. Remove insulation retainer plates.

Coil Reinstallation:

Reinstall new or cleaned coil reversing Steps 9 through 1.