User's Manual

SHARK SSG • 97-6134 • REV. 7/05a
OPERATOR’S MANUAL
PRESSURE WASHER
6
COMPONENT IDENTIFICATION SMALL
Pump — Delivers a specific gpm to the high pressure
nozzle which develops pressure.
Starter Grip— Used for starting the engine manually.
Spray Gun — Controls the application of water and
detergent onto cleaning surface with trigger device. In-
cludes safety latch.
Unloader Valve— Safety device which allows pres-
sure to be released when spray gun is closed.
Wand — Must be connected to the spray gun.
High Pressure Hose — Connect one end to water
pump discharge nipple and the other end to spray gun.
Adjustable Thermostat — Safety control which pre-
vents temperatures from going above adjustable set-
ting.
Note: If trigger on spray gun is released for more than
2 minutes, water will leak from valve. Warm water will
discharge from pump protector onto floor. This sys-
tem prevents internal pump damage.
Note: if flue adapter is installed, the burner assembly
air adjustment must be adjusted.
Discharge
Nipple
High
Pressure
Hose
Quick
Coupler
Wand
Spray Gun
Trigger
Nozzle Quick
Coupler
Burner Fuel
Tank
Water
Supply Hose
(not included)
Flue Adapter
Optional 7-10049
Insulation Gasket
Optional 7-01471
Burner
Switch
Pressure
Nozzles
Hour Meter
Adjustable
Thermostat
Starter Grip
Unloader Valve
Detergent
Valve
Pump