Corded 3-in-1 Cleaner WD100 Series OWNER’S GUIDE
IMPORTANT SAFETY INSTRUCTIONS 16. Use extra care when cleaning on stairs. FOR HOUSEHOLD USE ONLY. READ ALL INSTRUCTIONS BEFORE USING THIS 3-IN-1 CLEANER 17. DO NOT leave the 3-in-1 Cleaner unattended while powered on. WARNING To reduce the risk of fire, electric shock, injury, or property damage: 1. 2. 3. 4. 5. 6. 7. 8. 9. If the power cord plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
ASSEMBLY 1. Align the Pole with the opening in the Main Body and insert firmly until it clicks into place. USING YOUR 3-IN-1 CLEANER 2. Place the Storage Tray on the floor near FILLING THE CLEAN SOLUTION TANK a wall outlet. Place the 3-in-1 Cleaner on the tray. 1 Handle Cord Wrap Pole (Click) Storage Tray REMOVE THE CLEAN SOLUTION TANK Main Body Press the release button and lift off the Clean Solution Tank.
USING YOUR 3-IN-1 CLEANER MAINTAINING YOUR 3-IN-1 CLEANER CONTROLS SELF-CLEAN CYCLE The self-clean cycle automatically cleans the system and the brushroll. Recommended after every use POWER Press and release the Power button on the handle to turn on power. To turn off power, press the button again. CLEANING MODES HARD FLOOR MODE Use Hard Floor mode for powerful cleaning on bare floors. To activate Hard Floor mode, turn on the unit and tilt the handle back. RECOMMENDED AFTER EVERY USE 1.
MAINTAINING YOUR 3-IN-1 CLEANER MAINTAINING YOUR 3-IN-1 CLEANER MANUALLY CLEANING THE BRUSHROLL CLEANING THE DIRTY WATER TANK You can clean the brushroll by hand as an alternative to the self-clean cycle, and to remove debris or hair wrapped around the brushroll. 1 2 1. To access the brushroll, press the button on the top of the nozzle and lift off the brushroll cover. 2. Remove the brushroll by pulling up on the pull tab on the left side of the nozzle.
MAINTAINING YOUR 3-IN-1 CLEANER MAINTAINING YOUR 3-IN-1 CLEANER TROUBLESHOOTING WARNING: To reduce the risk of shock and unintended operation, turn off power before servicing. 5 LED INDICATOR The Water Droplet LED is pulsing red. The Water Droplet LED is pulsing aqua. The Area Rug icon and the three water droplet lights are flashing red at the same time. 5. After cleaning the dirty water tank and the solids separator, allow them to air-dry in a well-ventilated area for at least 24 hours.
MAINTAINING YOUR 3-IN-1 CLEANER Ordering Refills and Parts Replace the filter and brushroll every 6 months. THREE (3) YEAR LIMITED WARRANTY Only use Shark HydroVac™ Disinfectant, Shark HydroVac Concentrate, or water with the Shark HydroVac. The Three (3) Year Limited Warranty applies to purchases made from authorized retailers of SharkNinja Operating LLC. Warranty coverage applies to the original owner and to the original product only and is not transferable.
NOTES REGISTER YOUR PURCHASE registeryourshark.com RECORD THIS INFORMATION TECHNICAL SPECIFICATIONS Model Number: ����������������������������� Voltage: Date Code: ��������������������������������� Power: 200W 120V ≂ 60Hz Date of Purchase: ��������������������������� (Keep receipt) Store of Purchase: ��������������������������� TIP: You can find the model and serial numbers on the QR code label on the bottom of the back of the 3-in-1 Cleaner. PLEASE READ CAREFULLY AND KEEP FOR FUTURE REFERENCE.
PLEASE READ CAREFULLY AND KEEP FOR FUTURE REFERENCE. This Owner’s Guide is designed to help you get a complete understanding of your new Shark HydroVac™ Corded 3-in-1 Cleaner. SharkNinja Operating LLC US: Needham, MA 02494 CAN: Ville St-Laurent, QC H4S 1A7 1-800-798-7398 sharkclean.com Illustrations may differ from actual product. We are constantly striving to improve our products, therefore the specifications contained herein are subject to change without notice.