User Manual

sharkclean.comsharkclean.com
CHARGING CHARGING
STORAGE ON THE GO
CHARGING WHILE IN STORAGE MODE CHARGING THE HAND VACUUM REMOVING THE BATTERY
Charge the unit in upright mode by placing it on the
dock plate, with the hook on the back of the wand
over the charging post. Make sure the contacts
on the wand are aligned with the contacts on the
charging post.
When charging is complete and you need to use
the unit again, lift it o the dock plate.
To charge the hand vacuum without the dock,
unplug the charger cord from the dock and connect
it directly to the port on the hand vacuum, near the
nozzle opening. To detach the hand vacuum, press
the release buttons on both sides of the handle and
lift it o the wand. (See previous page.)
You can charge the hand vacuum while it is stored
beside the wand. First, detach the hand vacuum,
then slide the nozzle opening over the storage
post. Make sure the contacts on the hand vacuum
are aligned with the contacts on the storage arm.
When charging is complete and you need to use
the unit again, reattach the hand vacuum and use it
to lift the wand and nozzle o the dock plate.
To detach the hand vacuum from the wand, pull the
release buttons on both sides of thehandle, then lift
the hand vacuum.
To reattach the hand vacuum to the wand, align the
nozzle opening over the top of the wand and slide
it on until it clicks into place.
UPRIGHT DOCK CHARGING CHARGING HAND VACUUMSIDE-BY-SIDE DOCK CHARGING
HAND VACUUM RELEASE BUTTONS
STORAGE HOOK CONTACTS CONTACTSSTORAGE POST
For quick and easy short-term
storage, attach the hand vacuum
to the wand by placing it onto the
pre-assembled wand storage clip.
To remove, slide the hand vacuum
up and out. To remove the storage
clip, pull it o the wand.
First, lock the nozzle and wand in
the upright position, and detach
the hand vacuum (see previous
page). Hang the hand vacuum
from the wand storage clip, with
the filter removal latch sitting
inside the clip.
To remove the battery from the hand vacuum,
press the release tabs on the battery cap and slide
out the battery. To reinstall, slide the battery
into the compartment in the handle until it clicks
into place.
BATTERY
NOTE: When docked properly, the charging lights on
the hand vacuum will blink, indicating that charging has
begun. When charging is complete, all three indicator
lights will remain on for 5 minutes, then shut o.
NOTE: The main unit comes with a partial charge.
For maximum runtime, charge fully before first use
(approximately 3.5 hours). Leaving the unit plugged in
will not damage battery life.