Use and Care Manual
sharkclean .comsharkclean .com
Filter
Door
EMPTYING THE DUST CUP
To remove Dust Cup, lift tabs on both sides
of dust cup handle. Tilt dust cup, then lift
to remove.
To reinstall, place bottom of dust cup into
pod and then tilt until it clicks into place.
To empty debris into trash, press lower release
button and bottom of dust cup will drop open.
To remove collected debris from Lint Screen,
press top release button and lift handle to
open. Gently brush lint screen to clean.
CLEAN HEPA FILTER
EVERY YEAR
Press button at bottom of Filter Door. Tilt
filter door and lift out. Remove HEPA Filter.
To reinstall, insert HEPA filter into unit and
replace the filter door.
CLEAN PRE-MOTOR FILTERS
EVERY 3 MONTHS
Remove Dust Cup, then lift out Filters.
Regularly clean and replace your filters to keep your vacuum's suction power optimal.
To clean filters, rinse with cold water ONLY to prevent damage from cleaning chemicals. Allow
all filters to air-dry for at least 24 hours before reinstalling them to prevent liquid from being
drawn into electricparts.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
IMPORTANT: Unplug the power cord before performing any maintenance.
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
Replacement
Pre-Motor Foam &
Felt Filter Kit
XFFK560
Replacement
HEPA Filter
XFF5160
Follow the previous instructions for removing filters. The Pre-Motor Filter should be replaced every
2.5 years. The HEPA Filter should be replaced every 3 years.
REPLACING FILTERS