Install Instructions

5
Threaded Connectors
Teon tape should be used with threaded
SharkBite connectors to make a proper
seal.
Galvanized Tubing
SharkBite Universal ttings should not be
installed (threaded or push-to-connect)
on galvanized tubing.
SharkBite Soldering
When soldering is required near a
SharkBite Universal connection, make
all solder joints rst and then make the
SharkBite connections. Flame can cause
the pipe to reach high temperatures and
should not be used close to a SharkBite
Universal tting.
Sharkbite Fitting Reuse
SharkBite Universal ttings are intended
to be a permanent connection and are
not designed for repeated connection and
disconnection. If the need arises to change
a tting aer initial installation this can
be done given that proper care is taken
when removing and reinstalling SharkBite
Universal ttings.
SharkBite disconnect tongs or SharkBite
disconnect clips must be used when
removing the ttings.
The initial pipe and the new pipe must be
clean and free from scratches and burrs.
Mark the correct insertion depth, insert the
tting to the mark, turn the water back on
and check for leaks.
Working Pressure and
Temperature
SharkBite Universal ttings have a
maximum temperature of 200°F
maximum pressure 200 psi when used on
copper pipe. When used on PVC, CPVC,
PEX, PE-RT or HDPE refer to the maximum
pressure temperature rating of the pipe.
PEX Stieners
SharkBite Universal ttings (3/8" to 1")
come with an Integral PEX Stiener. 1/4"
(3/8" OD) ttings do not require PEX
stieners. PEX Stiener are required for
PEX, PE-RT and HDPE pipe. 2XL PEX
Stieners sold separately.