Specification

27
IAPMO RESEARCH AND TESTING, INC.
5001 E. Philadelphia Street, Ontario, CA 91761-2816 • [phone] • Fax [phone] •
www.iapmort.org
CERTIFICATE OF LISTING
IAPMO Research and Testing, Inc. is a product certification body which tests and inspects samples taken from the supplier's stock or from the market or a combination of both
to verify compliance to the requirements of applicable codes and standards. This activity is coupled with periodic surveillance of the supplier's factory and warehouses as well
as the assessment of the supplier's Quality Assurance System. This listing is subject to the conditions set forth in the characteristics below and is not to be construed as any
recommendation, assurance or guarantee by IAPMO Research and Testing, Inc. of the product acceptance by Authorities Having Jurisdiction.
Effective Date:
July 2013 -Rev. 1/8/2014-
Void After: July 2014
Product:
Push Fit Fittings
File No. 4630
Issued To:
Cash Acme/Reliance Worldwide
2400 7TH AVE SW
CULLMAN, AL 35055
Identification:
Each fitting shall have the following information marked on it where it will be
visible after it has been installed:
Name of manufacturer or trademark.
When a fitting is not suitable for all four (4) materials, it shall be marked as
follows for the materials for which they are suitable:
Copper or Cu
CPVC
PEX
PE-RT
When push-fit connectors are used on plumbing devices, the markings are permitted to
be on the plumbing device.
Fittings CTS or smaller are permitted to use a permanent label complying with the
requirements of UL 969 or CSA C22.2 N. 0.15 to display the required markings.
The markings shall be permanent.
The product shall also bear the cUPC mark.